Recent content by Caco4x4

If y could spin the base and put the filter upside down, would that be ok?

Sorry the picture is sideways, PTO is left side and filter is right side. I have used it quite a bit and noticed a dent in the filter, it grew until it punched a hole in it. They are so close together that maybe the the body flexes and hits it. It´s frame mounted.

Hi folks, the backhoe gear pump hits and breaks the hydraulic filter. Am I not connecting the PTO correctly? Could I flip the filter upside down or relocate it, somehow? Appreciate any feedback. Caco

HELP!! 😵‍💫

Upsss, must have done something wrong. Now I have 2 three point hitch controls. Remote connected to chipper rises and lowers the TPH :unsure:

Thanks again (y)

Now on to operation. I am familiar in general with chipping, but tractors and hydraulics are new to me. I think I'm fairly clear now with the feed mechanism. I start the tractor and activate the roller by tying lever in the forward position. Unfamiliar with PTO. I have dual clutch and 540/1000...

Excellent!!! So I can´t screw it up and blow something up.

Do you mean the fitting circled in white? How does it simplify hook up? excuse my ignorance. Pink goes there?

I bought it from Jinma with the tractor. Seems to be pretty solid. we´ll see when I get it running

Is this how it should flow?

Thanks for the info, I am starting to understand a little more, I did the bucket thing and the flow from the tractor when the lever is pushed forward comes from the top connector. If I understood right, the power from the tractor should go to the flow or speed control valve (blue) and the return...

I see no T´s, Shift is part of my ignorance, meant auxiliary lever. Took a better picture and tried to mark them. Hope it helps

DFKRUG, You suggest I now disconnect the 2 hoses at the chipper and put them into a bucket? From what I´ve read on this forum I should bungy the auxiliary shifter in the front or back position. Then start the tractor and see witch hose the fluid flows from and connect that port to the valve...

This is what I have so far.