Recent content by cbcbass

Speaking of bolts. During the time they had my tractor I asked the service tech to do a full service, grease everything, and check for loose bolts. Well the tractor sat in my barn over the winter and when I finally got back to using it, I did not think to check the bolts. After about 5 hours...

My tractor is back to working and I am a happy camper. Might as well close this thread.

It's the one with the prime on top, with electronic device on the bottom.

Got my baby back and found some issues. First, it took forever to get started. Then, it didn't have enough power to back up a hill. A friend was over to the house and looked at it and discovered a fuel leak at the bottom of the fuel filter. If I use the prime button, it will start and run...

Well folks, my tractor is fixed and just waiting for them to deliver it. Just three months. Huh.

That appears to be UF when all three wires are surrounded by insulation.

I agree. It appears to be UF by the color. Easy to put above ground or surface of ground J-box on both ends to take care of the wire going straight through. Then use the light wire for the new pump. You may be able to read the writing on the cable to determine if it is UF.

I talked with the tech working on it and it was the bolts for the ring gear. Bummer! I have never had anything like this happen before but, there's a first time for everything.

BTW: Are you working on it at Anderson or somewhere else? I would like to swing by and look at what you found.

It is kind of dirty and an old light blue shirt next to the seat. I hope it is mine you are working on. I have been down since March. If it is mine, do you think it was badly put together? Anyhow, send me a message via my email.

I talked with them yesterday and they finally got it into the shop. No status when they will break it down. Will update when I know more. Did you get yours from Anderson Feed in Dahlonaga? I am also in Cleveland GA.

I agree. I have cut a lot of roofing and I always use a metal cutting blade in my circular saw. Lots faster and the blade lasts a long time.

I went to the dealer and the tractor is just sitting there. They said there work load was backed up. hopefully, they will look at it this week. It is no skin off their nose. lol

Well, they picked up my tractor and said it may be a month to four months to get a new transmission. So much work to do and no tractor to do it.

I tried the differential lock with no success. I have called the dealer to come and pick it up. I don't have a clue how we will load it. lol