Recent content by Cedar Pete

Is 1/4" thick steel ok for forestry, or should it be 3/8"?

I found a different drawing that I think is correct. It shows the blue extend port going to the boom cylinders connected to the fwd port on each cylinder, as I'd expect. Hose is item 9. I can remove the far end on the left cylinder and i guess try to pull it all back out from inside the arms...

Hey Folks! Hoping somebody has a shared experience and can advise. I blew a hydraulic hose for FEL lift (extend, marked blue) near the big hose valve at the tractor interconnect. I've looked at JD diagrams and discovered a few things. They run their lines inside the steel arm tubes to the...

I got the same issue, what did you find out?