Recent content by coastie15078

Anyone out there use a Lawn Roller with their RK 24? I want to get a roller that is just as wide as the tractor or a little wider. Up here, East of Cleveland, the ground gets mushy at times with the rains, and I wanted to roll the yard flat. Any suggestions? Thanks mike

I bought a set of skids, however, King Kutter does not sell them for their blade, so I had to improvise, however, when I put them on, the angle is way off. In the picture, I have them on the front of blade, just to see if it made a difference, I since then have turned them around and put them...

I bought a set of skids, however, King Kutter does not sell them for their blade, so I had to improvise, however, when I put them on, the angle is way off. In the picture, I have them on the front of blade, just to see if it made a difference, I since then have turned them around and put them...

I got 2 mirrors for my Rk24 and no drilling required. There were already 2 holes on the FEL and there is enough clearance that nothing rubs. I did use rubber washers to try and eliminate as much vibration as possible and the best part is, they were only $18.00 for the pair. I use them while...

In reading the manual for the Rk24, it says when the Front End Loader is not installed, to turn this valve counter clockwise. And when the FEL is installed to turn Clockwise. Question is, what is this control valve for? And if you have Front End Loader and backhoe on, Where should the valve...

I have an RK24, and I was looking at the FEL today and noticed the O rings on both sides of the cylinder. Just wondering what they do? or if they came out of the cylinder? Just having a O ring on the shaft really serves no purpose from what I see... Any ideas

I found this today while surfing the web....going to use low range and 4wh drive while plowing snow Making a Hydrostatic Transmission Last Longer - YouTube Also, hypothetically: Lets say I am plowing snow this winter I have the Front End Loader On, as well, a rear blade on my RK24....lets just...

Another item was the 2 inch receiver.....I back my trailer using my truck, but where i store my trailer, i need to really caress it into a tight spot, so I use the receiver mounnted on the front end loader....after i back the trailer in, I take the receiver off....no holes drilled for either the...

One last thing, was on my back blade, i found these skids/ shoes to help me get over the uneven concrete, they are not meant for the RK Blade, and King Kutter does not make shoes, so I got these, I know they are on backwards, I was experimenting, If I put them on the back side of blade, they...

Since I got my Rk24, I have added a few things.... Bolt on front hooks on the FEL...... As well, I changed the small plastic box on the side so i can store more pins, bungees etc...I also put a note on box for tire pressure, as well, reminder for GLO PLUGS and to BLEED Hydraulics..... Also on...

Has anyone put additional lighting on their RK24. I to put additional light on ROPS, using an LED light and the power outlet on the right side....I was going to call it a cigarette lighter, but thats not what it is used for.....anyway, I was really trying to avoid running wires from batter...

Has anyone else had a problem checking the Hydraulic fluid level on the RK24?....When the backhoe is on, it's kind of hard to see in there.....any suggestions.