Recent content by cowridermi

  1. C

    Gehl 1470 Quick Wrap

    Does anyone have a parts list for this? I got the baler with the net wrap installed. Luckily it came with the supplement manual for it but no parts break down. Here is the supplement if interested. https://www.mediafire.com/file/l8qgawv938y8pua/wrap_supplement_a.zip/file...
  2. C

    Gehl 1470

    I need to replace the bearings on the shuttle on top of the baler, any tips to help do this?
  3. C

    Belarus 250as clutch finger height

    I need to replace a clutch in a 250as and would like to know what the finger height should be when installed. I could not find it looking at the manual, only peddle adjustments. Thanks
  4. C

    TMY 723PS f/r flashing on dash, no movement

    Thanks for the reply. I took a look at this but didn't find a problem but it makes sense that it is there. The other day I used the tractor for a couple of hours without fault. Then the next day it happened a couple of times, once after hitting some ruts and bouncing around. Most of the time...
  5. C

    TMY 723PS f/r flashing on dash, no movement

    not mentioned in owners or repair manuals
  6. C

    TMY 723PS f/r flashing on dash, no movement

    Mowing field about a hour when tractor stops moving, R/F flashing on dash and buzzer sounding. PTO still driving mower normal, engine temp normal. Shut down and check hydraulic, normal. Tractor starts right up normal, Forward engages normal. Mow for a while and it does it again. Turn off, on and...
  7. C

    TYM 723 hydraulics heat up using remote float

    Both the parts and service manual show this as a floating detent. Cylinder seems to float in this position. I went and attached a open hose on each port and started the tractor with it in float with no oil coming out. I may be chasing my tail with this. Need to set up a gauge to watch the...
  8. C

    TYM 723 hydraulics heat up using remote float

    I am using the float position on my remote when using a drum mower. The hydraulics heat up to the point that engaging gears is delayed. I have 700 hours on the tractor. My understanding of the valve is that the fluid should flow through the body the same as when in the neutral position so the...
  9. C

    Kubota D1105 engine injection pump question

    What or how does the Start Spring function?
  10. C

    No start problem Kubota RTV1100c

    Air filter is removed at this time and no blockage.
  11. C

    No start problem Kubota RTV1100c

    Helping out a friend with his RTV. He shut it off one day and it hasn't started since. He had someone else look at before me. From what he said the fellow removed the injectors and looked them over, replaced the fuel filter, had him put an electric fuel pump bypassing the lift pump, and had him...
  12. C

    IH single acting cylinder help

    I have a IH cylinder that I would like to repack but can't find it listed. The number on it is 381801R1. Thanks for the help
  13. C

    Massey Ferguson 1100 vent question

    I have a 1100 and can't seem to keep water out of the hydraulics. Is there a case vent for the transmission or rear axle housing? I can't seem to find one. Thanks for any help.
  14. C

    NH 479 haybine slip clutch

    I have a 479 that has the yoke ear broken off. Priced one at the dealer and figured for their cost I would try my hand at repairing it. Found a yoke to fit the cross, SKF UJ187305. I cut a portion off the bottom of the new yoke to get it closer to the height needed. I needed to retain the...
  15. C

    need yoke for New Holland 479

    I have the u-joint but the problem is that the yoke broke off one side, I need to replace the yoke. TSC has pto yokes but not for this size, nor is it listed in the Weasler catalog. Bearing Diameter A. 1.00" Overall Length B. 3-1/8" Lock Up Dimension C. 2-11/32" Inside...
Top