Sorry if I'm repeating what someone said due to not reading all of the conversations. I have a Rhnno 12TS that would bind when raised completely on one side. Turned out to be the PTO shaft for that wing. It was bent just enough to cause a problem when fully retracted.
After contacting Bryan 45 about his clutch slipping I checked my clutch linkage and found my cable outer jacket had split and was allowing the actual cable to slip out like a hernia. A temporary fix eliminated the slipping issue and now I'm waiting for a new cable to arrive. Thanks Bryan 45!
I took the covers off around the base of my FEL lever and found that the button has a short length of wire with a connector that is not connected to anything. I have seen the "kits" listed on the parts list for loaders at the Messicks.com for this tractor model. There are some companies that...
DB Pilot, to lower the three point a little faster I often press the auto lower button on the right side fender in against the spring. I assume your tractor has this function. Also on Youtube I saw a video by "CenTex Ag" make an adjustment on a Workmaster 75 which is the same tractor with blue...
Hello Bryan 45. I too have a 75A, same as yours except for the seat. It was purchased in February of 2019. Currently it has approx. 149hrs. I noticed a few weeks ago that my forward and reverse clutches were slipping. I hope that is is only a hydraulic pressure adjustment and nothing major. I've...