I picked up a Parker H series pump for a project. It has a built-in relief valve and flow divider. I was wondering if anyone had experience with this model? If I read the spec.'s correctly, I believe I can leave the secondary port and relief port blocked if not needed? *NOTE: ''D'' Circuit...
Hello, stripped my front drive (propeller) shaft again. Last year I just welded it up. This time around I purchased a new shaft and couplers. The diameter of the new shaft is larger than the old, which doesn't leave much clearance around the cover tube. Does anyone know if a new cover tube is...
New to the site and have a few questions about the 3215. Does anyone know the thread size for the ports of the hydraulic distribution block that feeds the loader valve? (#30 in the diagram) It is not a typical SAE (o-ring sealed) fitting. I need to replace the factory fittings and would like to...