Recent content by ecbaatz

Please, always check the water level in your lead acid batteries. Even maintenance free. Those caps are usually under the stickers. All batteries lose water, due to the break down of the water molecules into to hydrogen and oxygen gases, hence the warning no open flames while charging. The...

I have a Branson 2400H and I am having problems keeping the throttle set. There appears to be no friction to hold it in place. I tightened the nuts at the fuel pump (?) and that helped for a little bit but not now. Is there another place to get more friction? I looked at the linkage and I don稚...

I have a Woodmaxx TM-86H. It is a hydraulic fed chipper that runs off the pro. Nice chipper. Highly recommend in. I run it on a Branson 2400H.

I like my Marlin Camp rifle in 45ACP. Especially that fact that it takes the same magazine as my 1911.

No, but got a wood chipper for the tractor/

I have not yet received it, but it is ordered and paid for. It was this or a cab for blowing snow. This I can use more as I cannot use a cab for mowing in the summer. Overhead irrigation gets in the way.

Plus 1 on this,

I would have to say it depends on what you are cutting and how fast you want to cut it. I run a 6ft behind my Branson 2400h but that is to allow me to mow between the blueberries and maximize the cut. I also do not go very fast between them. It does cut my time down from 4 hrs to 2 hrs since I...

I added one to my Branson 2400h. It is round, though works great. Tied it into the cruise control fuse so it is only on when the tractor is on. I have attached pics although I am not sure why the camera did not pick up the voltage when on. Also added a 12v outlet, which is tied to a fuse block...

I was using my tractor yesterday to mow with a 6ft rotary mower. Hitch worked great lifted the mower without any problem. I then disconnected the mower and hooked up pto driven pump to irrigate (hitch not needed). Left it in the raised position. After I got thru irrigating I disconnected the...

This is mine.

Now I am really confused as my turnbuckles are on the inside of the lift arms. Do the larger horsepower tractor have them on the outside? Or is my 2400h put together wrong It is difficult to see but you can see the turnbuckle arm on the inside of the left lift arm.

This is one I attached to my 2400H. It can be removed easily by pulling on the u bolts at each end under the tool box.

I found a posting on craig's list for a AC-DC Miller Thunderbolt welder. The seller is asking $300 for it. It sounds like a good price as new on line is $653. But my question is, is this a good welder and even better is the price reasonable? Welder-AC-DC Miller Thunderbolt Thanks for the help...

Have you tried putting 12 volts directly to the solenoid to ensure that it is operating? The purpose of that solenoid is to prevent dieseling. The generator is normally shut off by grounding the coil and if that does not work then it will shut down due to lack of fuel. A way to get around it...