ernemats's latest activity

What do you mean by deutz engine plug?

Terry suggested eliminating fuse or circuit breaker and running wire without protection of fuse , start engine up and watch for smoke...

spent most of the afternoon checking wiring and could not find any wire damaged by mice chewing. When I start it up the circuit breaker...

Alternator was tested and it was good but said it was getting worn and was very dirty. I had them go overit and replace anything they...

Been using an old grinder wheel (teeth welded on) and the carbide inserts were broken off most of the teeth. Needless to say the old...

Took alternator off tonight will take it to be tested tomorrow

still have not found problem. Blew several more 30 amp fuses, put new wire from dash to starter switch to replace wire that insulation...

Bladder in pressure tank failed after 25 years

Not much good happening . Terry told me to try replacing 20 amp circuit breaker with a 30 amp fuse which I did, worked to start and run...

Hi fellas! Obviously I've been getting a few messages from some of you about these saws so I figured I'd join up and introduce myself...

I bet someday we all will own electric saws. It’s just a matter of time. So much more practical. Once the battery technology gets here...

Initial thoughts: Quality seems very good. Comes with a chisel chain! The oil and gas caps seem a little less robust than the...

I think that said 300, not 300k. That fits with "sitting on the lot". I'd be wary of that because 2 years is a long time to not move...

I'm sure you know the idiosyncrasies of your equipment well. A pair of the sharpest knives that I own were made by a guy sitting on...

Started it up yesterday and still pops the circuit breaker . Turned the pto on and nothing , reset circuit breaker and it started the...