Has anyone replaced the Oil vaptor seperator for the breather on there New Holland tractor? I have listed the part number above. My owner's manual does not even mention replacing it. The New Holland website under parts says to replace it every 300 hrs. If you have replaced, how do you remove the...
Bought new inner and outer air filters for it yesterday. Even though my filters are very clean it appeared that I had a tiny amount of dust past the air filters on the clean side of the intake. These filters are very cheaply made. The canister is made by Donaldson which is well known in the air...
Has anyone inspected there air intake behind the air filters and noticed a super fine light dust inside the hoses? I notice it on mine. I never really noticed it on any of my other equipment but was more concerned about mating surfaces being clean. I see no damage to either filters. All clamps...
I stopped and looked at a new 5045E today just to see what was different than my 5055E. First I will say its basically the same tractor just more refined. The operator station area I do like better but under the floor tin is the same tractor as before. I like how they done the floor now because...
My dad is thinking about buying a sub compact tractor in near future. He is looking at MF, Kubota, and Deere. What is the main differences between these two? I assume the E is more of an Economy model and the R is more fancy. I know there is 2hp difference. Where is the 100lbs. of weight...
I guess everyone has there own idea what an old tractor is. I am talking about 25 years old and older. We still have a John Deere 2155 and a Massey Ferguson 165 Diesel on the farms. I like the new stuff but I prefer the old. Just seems like allot more raw power and pulls allot better than the...
Has anyone noticed on there tractor the engine Rpm's increase maybe a couple hundred RPM's and stay there on its own. I noticed if I start my tractor every once and a great while, let it idle for a couple minutes, and then maybe increase the RPMS to 1200 that when I put it in gear and start to...
I noticed in the center of the bell housing there is a bolt that more looks like a drain plug. Also there is not paint on the casting around it. This appears to have been done on purpose by Deere. My manual does not mention it anywhere. I know most 2wd tractors have the cotter key there. I saw...
I was just wondering where the temperature gauge runs at on your machine when running it hard? Mine seems to run to the right of the half way mark around 60 or 65%.
Is there anyone on here that lives in an area with allot of New Holland Utility and Compact size tractors around being sold and used? Around here all of the New Holland dealers that have been blue even back to the old Ford days are now pushing Kubota. This really ticks me off but I must say...
The mechanic came out and looked at my tractor today. He pressure tested the system with tractor not running and later with the tractor running. He found another slight hose leak below the waterpump. This makes the 3rd and forth time the coolant hoses have been tightned on this tractor...
I have a TN70 that has the 8x8 non syncro transmission with the manual forward/reverse shifter on the left. The tractor has very,very low hours. I notice that when I push the clutch in and want to move the left shifter to forward or reverse at times it grinds especially if the rpms are up. Now...
I have a TN70 that has the 8x8 non syncro transmission with the manual forward/reverse shifter on the left. The tractor has very,very low hours. I notice that when I push the clutch in and want to move the left shifter to forward or reverse at times it grinds especially if the rpms are up. Now...
I have had several radiator hoses I have had to tighten up on my new tractor that I found leaking in the first 18 hrs of owning. I noticed the other day the inside of the radiator neck is made different than any other type of radiator I have seen before. Inside radiator in the center about 2...