Recent content by Fireman_Mike

What did you end up using for seals? I have one with a rebuilt motor I can’t get to stop smoking

Do you know if it has the yanmar or the Cummins engine?

Ok. I noticed you said in an earlier comment you barely use it and was curious if you're interested in selling it? I have a 3040 but it has a cracked head.

You still have that tractor?

Huckster who welded your head for you? I have the same head with cracks and need to get it fixed.

Thank you. I was having a no start issue and wanted to make sure that didn’t have anything to do with it. I think I have it narrowed down to the neutral safety switch

Can anyone tell me what the tractor in the upper left hand corner means?

I am looking for a Mahindra 2615 wire diagram. I have a service manual but can not zoom in on the wire diagram without distorting it.

So it was bearing #10 and #12, both on the same shaft. One those where replaced noise went away. The hydraulics are operating slow once I completed reassemble, but got the noise to go away. If anyway ask it’s a nightmare to get that bearing out. Tractor was split twice and all the plastic had...

did you ever figure out the problem?

So how big of a job is it to get to #12 to see if that's the issue? Also is there a way to attach a video to this thread ?

Some of us learn things the heard way I guess. I just have to try and figure out what bearing it is

The noise was the reason for the split. Yes I only replaced the bearing because my supplier sent me the single stage pressure plate and its a dual stage. The clutch disc was right but the old one micrometer the old and new disc and the old was .3145 and the new was .3360 not alot of difference.

Have a Case IH Farmall 31 that has a whinning noise when you release the clutch pedal. Once the pedal is depressed the noose goes away. I just split the tractor and replaced the release bearing.

It did look like lint and sludge.