Recent content by gravelman

Thank you for all of this....great advice It would be spring of 25

Not sure if this is the right forum...planning to move soon, have tractor and a number of implements with it. Easier to sell as a package or item by item??? I was hoping to find someone looking for a package deal but that may be too much to ask for. Any advice appreciated.

Im basically cutting a hay field, lots of thick weeds etc...no brush I think it is way too heavy for a finish mower... how about the old fashioned sickle bar

Id say you hit the nail on the head... you said it all. THANK YOU that is exactly what is happening.

deck is level and not flucuating.... i think im expecting too much out of it. I was thinking flail mower as i know they do a cleaner cut. THANKS FOR ALL of this

Yes sir...i did that when i mounted the mower to the tractor on a nice flat surface.... it lifts and drops down perfectly even.

Any suggestions as to what manufacturer has the best rotary cutter?? I have a Kodiak 5' heavy duty cutter and no matter what i do, i cannot get a full width clean low cut. One have looks good, the other half looks all stringy and leaves hay standing. I have changed blades, made sure only...

as a matter of fact i did twist that torsion bar....heated it up and got it as straight as i could. Might need another looksee thanks for that

great explanation...thanks much

hi folks, gravelman back with update on B2650 Kubota 2016 model. If you recall it started shutting down instantly when i applied the brake and SET THE BRAKE hold lever. I took the cowl off the dash, there is a safety switch that the brake hold lever engages... as soon as that happens the 5...

ok on all this...it is off by just a little bit...might just leave it alone, i could make things worse.

ok on all these...as always..THANK YOU ALL

on my Kubota B2650 the bucket is not sitting flat...one side up very slightly Im thinking bucket arms could have been twisted with too much pressure on one side.. Is there a little secret out there to fix...maybe try lifting the other way?? Or do i have to remove the pistons, bucket etc and...

update... my tractor has Operator Presence Control system (OPC) in other words safety shut offs. Anyhow, that 5 amp fuse was blown for that system....and it blew after applying the parking brake. Have not gone looking yet for where a wire is being scuffed or what is causing the fuse to go...

Yes, i will, reporting on these things helps us all. As we all know, there will be a "next time" too.