Recent content by Griff R

oops! Fusible link

It was the fusible off the starter. It powers the panel.

Do you know what might kill all power to the panel?

Nothing. BAT to ground on the frame gives me 12v but Jumping Bat to IGN or does nothing. Tried ACC too. and i do not get any panel lights at any time.

5 is IGN. when i do a continuity test on switch from bat to ign it shows good. When i plug the switch in i Get 12v on bat(which is 1) in the off position but nothing on 5 when i turn to run? Is switch bad even though it shows continuity from 1 to 5 in the run position.... can i stick a jumper...

6 terminals labeled BAT,ACC,ELX,IGN,ST,AID,GND

How would i test power out of the Switch?

tested the harness battery terminal to ground and got 12v. I have tried to test the switch but don't know exactly what to look for.

Have A jd 4400. Was snow blowing this am and when i went to turn on the flashers the whole tractor stopped with no power. The panel has no power. Battery is charged. Power is getting to the ignition key switch. All Fuses seem to be good...help!!