Recent content by harleyboy

Guys I just boought a used kubota F3060front mount. I'm looking for manuals (free) and a maual or advice on how to set the mower deck height ? it's a 72" side discharge Or Is the a forum for mower questions Thanks HB

Guys My CK30 HST sudenly has developed a squeak in the front some where? I thought it was the hydraulic issue that has been talked about but don't think so what do you think? It comes and goes but is louder in reverse. I jacked up the front right wheel and when turning the wheel by hand the...

CK30 hst Kioti BK2475 bh with sub frame. Am i to use the top link or not and why? HB

Hey guys I have to stand up an old style windmill about 15ft tall. I was thinking i could add a boom on the front of my CK 30 loader ???? How much have you added and lifted with your CK30? Thanks HB

I have a job to cut the grass on a berm about 15 ft high and about 12 ft from edge to crest. It is covered in grass weeds and burrdock. I know i could go out and buy a long reach mower but don't have $6k to $8k. Im also cutting with a non cabbed tractor so the the idea of a rotory mower is a...

The loader on my CK30 2010 model will not lift when full of dirt! When i had the BH added months ago i asked them to check the relief vavle and was told it was alittle high at2700psi. i know the newer tractors have smaller buckets. I guess all i can do is recheck it. has any one experenced this? HB

I had a very close call and was VERY LUCKY! I was just finishing 5 hrs of bush hogging and was heading back to load up. Driving on the gravel road trying to clip the edge of the grass and was fully aware of the ditch bank conditions as i had cut there before. No seat belt not going fast and...

When i brought my backhoe home I only got a 12" toothed bucket and decided a 24" ditching bucket would be very useful. So i removed the bucket and drew up prints and over the last month at work and home i now have a new bucket that works great. HB

When i brought my backhoe home I only got a 12" toothed bucket and decided a 24" ditching bucket would be very useful. So i removed the bucket and drew up prints and over the last month at work and home i now have a new bucket that works great. HB

I will keep this short as possible. Kubota G1800S 17hp Diesel starts good idles good but when cutting grass or blowing snow at higher RPM every so often it goes though a major loss in power to the point of almost stalling? If i throttle back for a few seconds it comes out of it normaly after a...

Is it my long legs or is the key position in a poor spot? I have bumped it getting off tractor and when doing loader work shuting off the tractor? Im not sure now to deal with this? HB

Hi I have read so many post on Backhoe's my head's spinning. If any one could answer a few questions please. 1 -What are your thoughts on the Kioti KB2475 BH and what was the cost? 2 -What type do you have on your CK30 do you like it and what was the cost? Thanks for your help i don't think...

Well i was going to make a box blade for my FEL to push snow next winter if this one ever decides to stop LOL. But low and behold i found an old McKee econo plow 6+6 snow blower 5 minutes from home. She's Old and rusty and needs some love but she works good. The dealer was asking $800 + tax but...

I Know go read this go read that and i have! I will be changing trans oil this spring at my 50 hr service and i think i have narrowed down to Mobil Hydraul Extra grade? or Amsoil synthetic tractor/hydraulic transmission oil (ATH) SAE 5W-30. I think these are very good oil and I believe worth the...

Just thought I'd show off my light project. Hope you enjoy not bad for $35 in lights and switches. The stainless steel tubing was free from work. :D