Recent content by Howard707

I am trying to identify whether or nor my system has the 6/12 volt resistor in the wireing harness. I have a manual with diagrams and they are not specific enough for me to understand. It is an original shop manual. I do have a wire coming from the coil to the solenoid and it has a thickened...

Hello folks, I have a 3cyl gas and have tried for nearly 2 weeks to get it to run properly. Sometimes it would run like a top, then it started acting like it was starving for fuel. I had already replaced the carb earlier this year. It was still under warranty so I got a new one and installed it...

Hello folks, I need a vacuum advance for my gasser and can not locate one. The part # is C5NF12370A. It does not seem to be available and was wondering if any one has a solution. I was told that other Ford distributor diaphragms will work, however, no one knew which one would. :confused:

HELP!!!! My tractor is killin' me. The bowl/seperator fills and then it wants to go down half way and causes the tractor to spit, sputter and cut-off. I have blown the lines clean, replaced the fuel pump, cleaned the separator, installed new stop-cock in fuel tank. I do not know what else to do...

I have a 73 Ford 2000 series tractor 3 cyl gas and it has been very well maintained. I replaced the carberator because it had some leaks and it was about 15 yrs old. The old carberator seemed to load when idleing. After replacing it, the new carb. seems to be doing the same thing. It starts...

Well I have replaced the cluth etc on my ford 2000. Runs great! Now the hydraulics are not working. The 3-point lift does not function at all. I bled the hydraulic pump and it did not seem to have any pressure behind it. The hydraulic fluid was flowing out, however, it seemed as though there was...

Hey folks, I have a 1974 Ford 2000, 3cyl, gas, 12volt generator tractor. One of the blades had broken off of the ignition switch assembly. I went to my local New Holland dealer and purchased a new ignition switch. The original switch has 11 blades. Only 5 were used on it. It has one over-sized...

Hi folks, I am replacing the clutch, pressure plate and throw-out bearing on my gasoline 74 Ford 2000 series tractor. I have the service manual, however, it does not explain how to remove the hydraulic pump. It has 2 lines that go the length of the tractor and I am not sure how to remove this...

Hi folks, I am replacing the clutch, pressure plate and throw-out bearing on my gasoline 74 Ford 2000 series tractor. I have the service manual, however, it does not explain how to remove the hydraulic pump. It has 2 lines that go the length of the tractor and I am not sure how to remove this...

Hi, My name is Howard and I have a small farm in Chesapeake, VA. I am trying to get information in regard to an FMC Bean Sprayer and do not know where I should post my question. I am glad to see that we have a place to post questions and give support to other farm owners and homeowners.