Recent content by Jason280

Thanks for the information. I know the last time we did a service, I used a Shell(?) equivalent...it was a decent amount cheaper than the Kubota version. This was the first time we used the standard Kubota stuff, but only poured in maybe 1-2 gals.

I've always read that the HST tractors required the Kubota UDT2 or Super UDT hydraulic fluid, but any potential issues with running the standard UDT in an L48 with HST trans? Ours was a little low on fluid, so we added around 2 gals of the UDT (not realizing it wasn't the UDT2). Any potential...

I just ordered the kit, should at least be able to figure out where the PSI is now...and whether there is any room to bump it up.

Never updated this thread, but I was able to find them online...ordered a pair, and sure enough, ended up having to replace a second one.

That's one thing I haven't found quite yet, the exact spec for the hydraulic pressure in the system...can't really go forward until I have that bit of information, but given how the FEL operates, I have little doubt its low. Everything else about the tractor is great (with the exception of the...

I bought a new MX5400 a few years ago to replace an L4330, and have been fairly happy with the tractor. One thing I have not been impressed with is the lift capacity on the FEL, which has never felt as strong as the 4330. After watching a few vids, I am convinced the relief vale on the...

I can't remember for sure, but I think most of mine have 18tpi blades (really need to check to be sure). I think I'm up to four Milwaukees and one DeWalt now, the Milwaukees are an older 24v, two 18v, and a 12v. The DeWalt is also a 12v, they are probably the ones I use the most.

What type hose do these setups use?

Local yard has this parked on top of a pop up camper, and is willing to sell reasonably cheap. I thought it was one of those portable pressure washer setups, but looking at the pump, I'm curious if its just a sprayer setup for farms. Anyone familiar with these have any ideas? Supposedly, the...

There isn't an Agri-Supply location within 2 hrs of me....would be a lot easier to simply order.

I have a Brown BDH-600 disc harrow, and one of the outer bearings on the rear of the disc row locked up. I've found the parts list on Brown's website, and looks like the entire trunnion/bearing assembly is DH-115A, which includes the trunnion (bearing housing), inner bearing, and c-clip. The...

Details?

I'm not sure its possible with this style safety switch. Its installed into the bottom of the seat itself, and extends into the actual cushion portion of the seat. Its not a lever style where weight on the seat frame engages, you have to push down on a specific portion of the seat. I really...

While this is the simplest option, I don't necessarily like the idea of completely disabling it...that being said, its too much of a PITA right now to not so something about it.

I bought a new MX5400 in '22, and I am almost ready to completely disable the seat safety switch. It entirely too sensitive, and and just about any change in position on the seat will shut the tractor down. I'm 170lbs, and its aggravating trying to run/watch any implement behind you without...