Recent content by jcalla

CH4, Good idea, I might try that. I finally got a parts guy that knows what he is doing and he ordered one. Hopefully it is the right one. Thanks all for your suggestions. JPC

Been There, Thanks for your reply. The link did not show the line. The model loader is 400R with full (6) connectors. It is the lowest line one the disconnect plate from the tractor to the loader. The other end is the second from the front on the block underneath the right side of the...

Been There,

I split the hydraulic line again. I repaired it with silver solder but I need to replce the steel line. I cannot find the individual line on JD parts. It is the curl ine for the bucket. It goes from the block to the loader. Can anyone tell me how I identify the part number? JPC

Since we are talking mower blades, does anyone know where I can find a left hand (CCW rotation) blade equivalent to Oregon 396-612 specs? This is for my finish cut AMF 4214 Landpride mower. IMO, The OEM blades are not beefy enough for the machine. I have searched high & low and I just can't find...

Happened when I was curling my stump bucket. It was about an inch long, looked like someone sliced it with a razor. I had already done the heavy work removing the stump. Has anyone ever had this happen? I took it off and closed it back up and silver soldered it. Works fine.

I have added a 3-5lbs PSI inline fuel line pump to assist fuel getting to injection pump. Cleaned pick up screen on intank fuel pump. The leak is on the high pressure side, it should not be affected by supply side pressure. I have new OEM O ring seals for top fittings on order. I just replaced...

T, try it now J

T, Attached you will find OEM number on second page. J

T, The mower is a 2017 Landpride AMF 4214 batwing finish cut pull behind mower. I want something heavier than OEM blades. The OEM blades are listed in the attached description for the Oregon blade 596-627. This specs out pretty close. Also, I like Oregon 396-612 because it is a little thicker...

Yeah, I been trying for several years to find heavier LH blades for my Landpride batwing finish mower. Stock LH blades a just 2" wide and don't have the force I am looking for in heavy areas.

I am looking to find a left hand cut or CCW rotation mower blade that has the same specs as the attached file. Could someone please point me in the right direction? I just am unable to locate one. see attached files showing specs of Oregon 596-627 Thanks

I would like to add an additional step to my 2010 4720. Looking for a good link that has a bolt on additional step.

Turbocharger & exhaust manifold are white. Should I replace my turbocharger? JPC

I have checked rear remote scr's & none are stuck. This just seemed to happen after I got into some real heavy grass and did not ease up right away. I have used it since and it runs ok until I get a load on it. Then it hisses like fluid is bypassing a port and also the engine pours out black...