JJT's latest activity
-
JJJT reacted to lilranch2001's post in the thread Anybody here ever make money gambling? with
Good Post.
I never found it very thrilling to give my money away….. -
JTwo rules 1 Realtors live to sell, whether they're the listing agent or the 'buyer's' agent. If a house doesn't get sold (or bought)...
-
JJJT reacted to SteveS42240's post in the thread Trailer wood deck treatment: Brush on used oil, linseed oil, sealer stain, unicorn tears...? with Good Post.
I have a 16' trailer that has had pressure treated wood on it for more than 30 years. My brother bought it and a used tractor in the...
-
JJJT reacted to oosik's post in the thread Need advice regarding a "city boy" coming to rural property with Good Post.
I would really hesitate on any sharp, spinning equipment. Accidents WILL happen before anybody can stop them. My son, and a friend of...
-
JIs propane iffy because of poor access to your home? Or few area supliers? Could you get another tank buried & filled as a larger...
-
JMy last Stihl top handle Arborist saw set me back almost 700 bucks and then I ran it over with the bucket truck and it was junk. Wasn't...
-
JFound used Echo CS300 locally for $300
-
JEcho has to be the easiest saw to start IMO.
-
JTypical failing coil symptoms. While it is acting up, DO NOT wait for it to cool down, immediately pull a plug wire and check the spark...
-
JI've run over literally, thousands of them and never had one problem. Then again, I don't drive on junk or wore out tires. SR
-
JJJT reacted to plowhog's post in the thread What is the fastest way to burn a pile of logs? with Good Post.
Spent the day burning today. What became obvious is that based on fire size restrictions, I won't live long enough to work through the...
-
JI didn't go cheap but elected for foam filled which did two things... added weight and no more flats!
-
JThe 24 series machines do not have a low center of gravity, only the 14 series. Look at pics of the 425, 1430 through 1460 and you may...
-
Jthe machinist, measured the inside diameter of the pipe and then turned down the pin to the size of the pipe inside diameter, then...