I have had this tractor for 30 years. I added a Koyker front end loader 25 years ago and added a Case 125 backhoe to it 15 years ago. This is an open center system. I turned this farm tractor into a backhoe is what I did. All has worked well until this week. While using the front end loader to...
Just to follow up on this. I got the tractor put back together and everything works as it should. Previous fluid aeration problem is gone and MFWD/2WD switch is now working properly. Nice healthy system pressure too at 250 psi.
That syphon spray gun might work. There is one 90 bend in the pipe and its a pretty good diameter like 3/4" ID. I thought about running diesel fuel through a pressure washer :) straight into the hole. The large lower left hole is the one I have to go after.
I connected a 300 psi gauge to the System Pressure port today and I have 230 psi at this port after I crank the tractor. This seems to be normal. Releasing parking brake momentarily drops this pressure to 150 for a second, but then its right back up to 230. Then after 10 minutes or so of...
I have a new to me JD 310E. Today while operating the backhoe, the battery light came on and I noticed that the hour meter has also stopped running. I pulled the panel face where these reside and didn't see anything obvious. Any tips, wiring diagrams or links to such things greatly appreciated!
I'm headed to see a Trans Mule and just wondered if I can squeeze it in the back of a 3/4 ton Chevy Pickup w/ 8" fleetside bed. The mule is listed at 57.5" wide while the truck bed measures 59". Has anyone done it???
Also, this is a one time deal.
Has anybody done this? I have a YM 2310D with the standard dynamo/regulator setup that has gone kaput. I'm interested in going to a 1 wire GM alternator. Anybody here done this?
When I push in the clutch on my Yanmar 2310D, my PTO stops turning until I let the clutch back out. This makes me wonder if I even need a over running clutch?
When I engage the clutch I can hear a slight noise from the throwout bearing. I would like to put a little oil on it. I've notice a rubber plug in the side of the bell housing and wonder if it might be possible for me to use a seeSnake type borescope with small oil tube attached and oil the...
As some of you know I bought a 10+yr old backhoe a few months ago. After a couple of days use the dipper cylinder started mudding the rod. I had noticed the wiper was all cracked up and didn't think too much about it. Apparently dirt gets in next to the packing and just kinda sits there until...