Joe Hickerson's latest activity
-
JJoe Hickerson reacted to Walter L's post in the thread 75 hr review on Mahandra 2660 cab tractor with
Good Post.
2660 tractor built by TYM with a Mahandra engine with auto shuttle control , originally I didn’t like the auto shuttle but have always... -
JJoe Hickerson reacted to rc70070's post in the thread Mahindra 2540 Wont go into gear with Good Post.
So at the end of the day, the linkage cable was bad and had a bad bushing in the lever(the lever is no longer a replaceable part...
-
JIt lasted 10 years. I'm just going to cave and rush order one from my dealer.
-
JCorrect.
-
JJoe Hickerson replied to the thread 5500 KMW Loader Pivot Pin.Mac, is that top pin greaseable? It doesn't appear to be. So it would be the same situation as the bottom pin just out of frame which I...
-
JI forgot the picture. Note that the upper pin that sheared off is hollow, but the lower pin is solid. The pin out of frame bottom...
-
JThe Mahindra 1 x 4-1/8" pin is hollow and after only ten years of abuse sheared off on one side. It is the upper pin in this picture...
-
JRerouted the exhaust with a 17/8 45 degree elbow, moved the light switch to where I didn't turn on the signal lights every time I got on...
-
JJoe Hickerson reacted to MrMark2015's post in the thread 2015HST crawling forward with foot off the forward/reverse pedal with Good Post.
MarcoOL - Glad I came across your post 5 years later. Hoped on you figured your issue out as I bought a 2015 last year that is having...
-
JJoe Hickerson reacted to Gregster613's post in the thread Mahindra 3510 hydrostatic model hydraulic dipstick location with Good Post.
Mattyboy, What ptsg said about the fluid level is very true, I'd suggest you get some JD dye and add a couple drops to the fluid you are...
-
JJoe Hickerson reacted to Utterchaos's post in the thread Mahindra 2525 Clutch Adjustment with Good Post.
The hub spline on most clutch disks have one side longer than the other, if it’s flipped the wrong way it’ll prevent it from releasing...
-
JJoe Hickerson reacted to kneedeep's post in the thread 2008; 3510 (New Sheet Metal) 4WD Lever Leaking HYD Fluid with Good Post.
Change the hydro fluid while you are under there, might as well change engine oil and fuel filters.
-
JJoe Hickerson reacted to Harry in Ky's post in the thread 2008; 3510 (New Sheet Metal) 4WD Lever Leaking HYD Fluid with Good Post.
While the oil is drained would be a good time to pull and clean the hydraulic suction screen. It's only a few inches away from the shift...
-
JJoe Hickerson reacted to TheRetiredBear's post in the thread 2008; 3510 (New Sheet Metal) 4WD Lever Leaking HYD Fluid with Good Post.
Harry, Thank you for the part number. I ordered a couple of the O-Rings from my local dealer and when they come in, I'm going to give it...
-
JThat thing is worth its weight in gold at your new place!