Recent content by Johnkn

+2 on SureTrac. I now have 4 of them. Latest is a new 14k tilt I picked up this Fall. I would not hesitate to spend a day driving for the right trailer or vehicle that will last years. Good luck. .

I have a Ravelco on my TRX, it is not going to be defeated and the truck will not start w/o the cap. There is no single device that will prevent all theft (ie: flatbed) however multiple steps help. Good luck... .

Where do you see 2250 at the pins? .

i know how to read Kubota loader/capacity values, that's not my question. Again, the specs suggest almost no increase in capacity between the LA535 and LA545, however some of the actual testing suggests otherwise.. .

I understand the pin and pin +1.5 numbers, but no, the specs suggest there is almost zero difference in the old and new loader, 33 lbs at the pins and 1 lb at pin +1.5M .

I have an extremely low hour LX3310 and could use an extra few hundred pounds of loader lift capacity and was considering a new LX4020. I thought I read and saw online that the new FEL on the LX4020 (even though the designation LA535 vs LA545 does not suggest it) was much more capable and...

I'm considering swapping my '21 LX3310 TLB with only ~65 hours for a 4020, I can use the extra FEL capacity. Am I the only one unable to get to the KubotaUSA LX pricing page online? Edit, Ahh, I used the link above and that works. The kubotaUSA "build' link is wrong now...

Thanks all. .

The rear tires on my Kubota LX are dealer filled with alcohol mix. I’m going to install the BH and just leave it on moving forward and I understand it's not advisable to run filled tires with the BH. I'd like to drain most of the fluid from the tires but with the valve stems in the 6 o'clock...

My LX3310 is at the dealer for its 50 hour service. The dealer stated it would be finished tomorrow after the required “Campaign” (SW update) was completed. Exactly what does that do? Thanks .

Thanks all....... .

What’s an approximate, reasonable cost for a full 50 hour service on a LX3310? Thanks .

Wow. No one knows..... .

I can’t find it in my manual, what’s the stock pressure spec on a LX3310? And the valve is between the 2 hoses under the tractor adjacent to the right rear tire, correct? Thank you .

Get the big one now, or wish you did and buy it later to replace the one you bought today..... .