Recent content by jrd1990zr1

When I got this tractor it has a gearbox with a flat belt pulley attached to it. I removed the bolts but it appears something else is holding it to the PTO shaft. Is there something else which needs to be removed to take the pulley assembly off? Thank you in advance for any advice.

I have a leak where the governor is mated to the flywheel case. Seems like it should be an easy repair. Is it as simple as it looks to remove it and replace the gasket? Is there a torque recommendation for the 2 bolts? Thanks in advance.

I recently became aware of a 2018 Kubota BX2380 with a LA344 loader and factory cab which might be for sale. 14 hours on the clock. I am having some difficulty researching a reasonable cost for the tractor since many low hour tractors are either newer, have no cab and include a belly mower...

I have an older Ford 9N which had a PTO driven buzz saw table attached. The flat belt saw had no guards so I removed it. I noticed the 3 point lift arms will not lift. Any advice on where to start to fix this? I have limited repair information (manuals) on how the system works and before I...

New to this forum, hope this is in the right category. I am looking for a source for a used Ford rim for a model 1320. Rim is stamped 11X16. Center (hub) hole is 4-1/2". 6 bolt, diameter of bolt circle is 7". Anyone know of a source or someone parting a 1320 out? Thanks for the help!