Recent content by JWD1312

Could someone post a couple pic's of the plow blade, I'm thinking a building a rotary plow for my TPH. Also what would the rpm be of the blade. THANKS

I have a 8hp brigs motor(vertical shaft) I'm going to put a 4gpm pump on it with flexible coupling. Do I buy a CW or CCW pump. THANKS

I'm building another trailer, 6x10' and I want it to be a single axle dump tailer with 4000 lb capacity. I don't want to spend $600.00 on the hydrolic system so, what about making a tilt trailer where the main hinge pins are right in front of the front leaf spring hanger, which would be 5' from...

I"m going to buy a drill press since I burnt up two half inch drills building attachments . Is 240rpm slow enought for drilling and slow enought not to heat the bits up. Also where is a good place to buy or order one.Harbor Freight has one for $139.00 3/4 horse.

NEED ADVICE( can\'t find D-rings in town) Would something like this work, it;s 3inch by 3/8 thick angle with 1/2 inch side gussets. I think I would put about 6 on the trailer. I would like to see some pic's and hear some other ideas. Tractor is a Kubota 7510. THANKS

I put dirt guards on both sides to stop it from wind rowing (think thats what you call it)the dirt, I used it last night on a 2000 sq. ft. side yard work great.

STARTED WITH THIS

Looks like about 2 or 3 weeks an it should be done. we have snow in the forcast next week, that will slow me down.

Would like pic\"s of TR3 I would like to build something like the TR3, the only pic I"ve seen is on there web site( not much detail) Anyone have some good detailed pic,s to post? THANKS

NEED PIC\'S OF GAUGE WHEELS I'm building a 60 inch landscape rake, just getting it ready for paint and then put the tines on. I want to build the gauge wheels myself too, NEED SOME IDEAS(PIC'S)

Is there any problems pointing the lift pins in , instead of out on this 3ph for my landscape rake?

I need a single acting cylinder about 40 inches retracted, 4 inch piston, 2 inch rod, 30inch stroke , for my dump trailer. I'm going to use a 12 volt power unit(single acting with solenoid valve) I can't seem to find the right size single acting cylinder anywhere. Can I use a double acting...

I just got done cutting down and welding back together my axles for my dump trailer I'm going to build this spring. They are 6000LB trailer house axles , one set has brakes(hope I can get them to work). I bought 5 axles about a year ago for $80. These are the last two, the others went on...

I was wondering if anyone out there has any ideas or pictures of a home built cement breaker, either tractor mount or stand alone. Something that would break up cement drive-ways or sidewalks.

I have plans for the caddigger 841 but I don't like the pivot fixture using the brass thrust bearings. MY question is how would half of a I-beam front axle (using the ball joints too) off a very big truck work for the fixture. ALso anyone have info on the ubuildit Ground Hawg backhoe any...