Recent content by Kenn1320

Wow this is an old post, but I just ran into this same problem. The dealer said Dukin bought out Besko and there are no parts available. The new valve is $2100. I see you were quoted $850 back in 2019. Ill have to look up the valve in the link you scavenged the parts off of and see how bad this...

Wheel is almost 6" and uses a 5/8" bolt that has a bushing with needle bearings. All the wheels on Amazon are 5" or less, but more importantly only 1/2" hole. They don't appear to have bearings either.

Sorry guys, yes I got the cover. It worked great until this year(2022). The cover started to rip. I bought some sunbrella material and built a new one.

I have a mid mount mower on a lsj2030. The 2 front deck height wheels can swivel 360 degrees. When I back up, then go forward the wheels turn sideways briefly and scalp the lawn. I have set them touching constantly to not touching at all,same results. If it contacts and its sideways, divot. I...

I'm still investigating it, but battery was low cause it kept stalling. Put the charger on it for a few and fired up and stayed running. Almost like there's a sensor if it doesn't read a certain voltage it shuts off. Its original battery, needs replacing. The local battery shop said they don't...

Ok guys, didn't see this topic when searching. I run a stick up into my fan, blades sheared off. Replacement part was around $20 shipped on Amazon. Fixing it wasn't straight forward, but after reading this, it will be easy for you. You will need 10mm, 12mm, philips screwdriver, hammer, punch or...

thanks, I bought a 4ft and it works good. I had times it was bogging down the machine, so probably best I didnt go with the bigger one. Really depends on the ground and weed/roots. I tilled a fresh cut field, so had to go pretty slow and lots of debris. In the future I think a glysophate...

Did you figure out how to hot wire it? My 2030 had starting problems. Tractor would run fine, next day start and shut off instantly. If you hold the key briefly it stays running till you let go of the key, then dies. I try 5 or 6 times and leave it sit for awhile. Sometimes it will fire right...

I realize this is an old thread, but I didnt find much info searching on here for a tiller. I had borrowed a 5ft tiller for my J2030h and it seemed to do ok, but I did break one of my 3pnt adjustable links. Im guessing it didnt like me turning with it down. I replaced with chain, so those little...

My J2030h did the same thing. I replaced the instrument cluster and that fixed it. A year or so later its doing it again. Something is getting wet it seems and causing the issue on mine. I store it outside with a cover. Ill have days where it will do that in the morning and Ill wait and try...

Well I replaced the dash and that fixed the issue. Im resurrecting this old post because 109hrs later its doing the same thing again. Starts, hear a click and dies. If I hold key it stays running till I let go of key, clicks and dies. Looking like I need to order another dash😡

Something strange is going on with my J2030 tractor. I had the fuel can slip and a good amount of diesel went over the hood on right side(if your sitting on it). That is when the problem started, or so it seems. The tractor will start fine, but try to go forward or backward, or turn on mower...

Built a 3pnt/tow behind cultipacker. Havent tried it in tow behind mode to see if there is any difference in performance, but it works pretty good in 3pnt mode. Center tube is 3x5x1/4" wall and end plates are 1/2". Center tube is filled with old wheel weights. Axle is 1 3/4" cold rolled steel...

Good news guys, turns out I hit an exposed root and dented the deck. It doesn't take much, cause I put a heavy duty crescent wrench on it and straightened it out. Sorry if I scared anybody, I thought the issue was more serious. Pic is orientated so left side of pic is front of deck.

Looking at getting a cover for my LS J2030 and covermytractor.com has a nice one from what I hear. I wish it covered the fel, but it doesnt. I noticed the price is $435 for the LS, and for giggles I went to the NH Boomer 25(I believe they are the same tractor?) and the price is only $325. Will...