Recent content by Knight

I bought a 773, maybe a 2000. It has Keyless start and is unlocked right now. I have a Master code, but need help setting an operator code. I can't seem to find anything out online, as far as the procedure for setting it.

I'm considering letting go of my 60" harley rake, since I don't get to use it much. Actually, I don't think I used at all other than trying it out. It's been completely rebuilt to new condition with new chain and sprockets, bearings, paint, etc. I'm not trying to sell it here, I just wondered...

5' harley rake 3-point attachment. Like new condition. Completely rebuilt. Brand new drive shaft and clutch, All new pillow block bearings. transmission has all new sprockets and new chain. New tension springs. New tires rims and bearings. Repainted Kubota orange and gray. Only thing missing is...

While restorting as harley rake I decided to add a slip clutch because of the damage encounter by rollers jamming, chain jumping sprokets and pillow block bearings breaking. As I was removing the old coupling from the gear box, it had a friction clutch. I never seen one before. It had springs...

Ever see a slip clutch mounted on pto of tractor??... right at the tractor? I picked up a Harley rake and it has no slip clutch. Right on the PTO might be the easiest place to add it.

I want to install a slip clutch on a Harley rake. I think the best place would be on the gear box input. I have a 1" keyed shaft on the input gear box which the drive shaft connects to now. All the clutches I see have 1-3/8" fittings. How can I go from PTO Shaft to clutch then to 1" keyed...

I was looking a a Scag Tiger cub for sale The guy says it's 4 years old. It has a 26Hp B&S 3600 hours. He wants around $3500 for it. Does this seem like a lot of hours for 4 years?

I need to have less retraction on my grapple cylinder. For example if my pin centers are 16" when retracted, I would need the pin cylinder to be limited to 17". How can I do this?

When it closes, It ends up ripping the grapple frame apart if I hold the valve too long. It's a 2 1/2" cylinder and I need a pressure relief valve. Put I only want pressure relief on this cylinder only. How do I do it?

I have a hydraulic cylinder for my tilt. It has a 1" swivel end and my bolt is 3/4". I can't find a 1" to 3/4" reducer. I would even buy a new top link bolt that had a 1" end as another option.

I suspect a woodchuck. I have seen one around. I have a fence, but he maybe getting through. How do I get rid of him, no guns there are other houses around.

Tilt cylinder control valve I was going with electric over hydraulic, but know I am changing plans. I would like to select a single valve for my L3400. Tandem center valve, single spool. Any links to a valve would be great. Does this look right...

I bought a side link cylinder from SC with Sae 8 ports I need a 90 degree fitting into 1/4" Hydraulic hose.

Kubota L3400 Where is a good source for a tilt cylinder? Can you even buy a cylinder made up with the proper ends or do you have to make your own? What is the Bore and stroke?

I have the woods 750 BH now, but I have a line on a woods S9000. My front and rear tires are foam filled so I have weight. (foam is heavier than calcium filled tires...go figure) Just wondering whats the smallest tractor that this wood s9000 can go on. The woods weighs 1300#, I don't know what...