Recent content by KountryKevin

There is definitely not a grease fitting for lubrication. I just checked the Operator's Manual and there is no mention of lubing the spindles.

Breaking might have been a better term to use.

Thanks for the tip. I assume you are referring to part 65 in the diagram below?

Greetings, last week my 50" mower deck threw a spindle assembly. So, I ordered a new one and installed it, along with a new belt and blades. Then this week, the deck threw another spindle assembly! So, the question is, are these spindle assemblies simply at the end of their useful lives (~8...

Thanks for the insights. I thought a couple of pictures might help. I have replaced part 49040 (fuel pump) and tubes 92912, 92192A and 92912B. I also swapped out part 21188 (solenoid). Part 11013 (air filter) was changed and is clean. Question on the diagram with this part: Check out part...

Problem (short version) Tractor runs for 10 20 minutes mowing the lawn with its 3-blade 50 deck and then quits. Let it sit for 10 minutes or so and it will start again but quit again in a shorter period of time. Problem (long version) Bought the tractor/mower at an auction. It was not well...

Hello TractorByNet community. New member here. I am in the process of moving from the burbs to the country. I have two lawn tractors right now (JD L110 and CC LTX 1050 KW) but may upgrade to a "real" tractor if the other two can't handle the new property (3 acres). I currently collect...