My mf 135 finally blew a rim.question is can a good welder cut out my old hoops and weld them in a new rim.my rim measures 12inches outside lip to outside lip so i guess its a 12x28.or anyone have a good source for a replacement? By hoops i mean power adjustable rims
I need a 12x28 spin out rim which is very expensive.( no my old one cannot be repaired)
Is there a mor inexpensive way of replacing it with a clamp on?
My cub 1042 kw wont stay running under a load.
Good fuel and cap off, and cked for spark.will run for ever with no blades running but wit blade. And high rpm may run a minute or 5 minutes.
Also the tube at the top of the fuel tank, where does it go??
My mf 135 gas with a Perkins 3 cyl. Seems to be running rich, I be ieve the float is adjust properly, it also has a new needle and seat. Idles ok, I think it is a carb problem because when I go up hill it cuts out, this is the zeienth econo mizer carb,,all jets and orifices clean, can a carb...
my 70s model mf135 will move a little when the clutch is pushed in? but my real concern is I cant get the pto to engage? no grinding noise and i can feel a drag on it? is ti an adj. or any suggestions ??? thanks:confused2:
I have an 80s model 135,,,can some one tell me how to set the ign. timing how to fill the hydralic and the transmission,,,,,,,,,,,,also i cant seem to shut off the pto??? and what areall the levers are for??