Recent content by KubotaSam

If you lock the "flow control valve" the 3 point hitch will stay up , but also the mower will stay up. The lift power for raising the mower is supplied by the 3 point hitch raising. As far as I know there is no way on a B7800 to keep the 3 point hitch in the up position and have the mower on the...

Check for corrosion where the wiring harness plugs into the back of the instrument panel. I bought a B7500 a few years back and the temp gauge acted kind of like what you are describing. Turned out to be corrosion as I described.

Here are 3 pictures of one I had a few years back.

My step son borrowed a friends 2016 JD 2025r to do some bush hogging around his house. Everything was fine on Saturday. Today when he went out to cut some more the pto was acting up. As I understand it it is an electrical switch that engages it. Sometimes it will operate for 5 to 10 seconds...

I just bought a 3 point hitch mounted Ford 715 snowblower. Looks to be in really good shape. Does anyone have access to a PDF of the operators manual that they could share or advice on where to download one. Thanks Sam

My brother was cutting hay with my Dads old Farmall super A. It has the factory sickle bar mower with a 7 ft bar. While mowing the cutter bar broke in half. I welded it but doubt it will hold. Does anyone know of a source for a new cutter bar for this farmall mower? Thanks Sam

I am trying to help a friend with a Ford 1700 diesel tractor. I know it was built by Shibaura. He says it has issues with the wiring being bad behind the dash. Can anyone post a wiring diagram for this tractor or point me to a web site where I can down load one? Thanks Sam

I think you will find that the yoke is held on to the gear box with a nut in the center like the yoke on a truck differential. (see pict) You can not use a regular shaft like Tractor supply sells because the yoke is totally different. If you can fine the correct size of the other end of the...

Here is page 10.

My newest B7100 Kubota has what I believe to be an aftermarket FEL installed on it. The tractor is early 1980's and the loader looks to be of the same vintage. I think I can make out the word Hardy under the paint on a front cross brace. I will attach some pictures. If any one can help with a...

I just bought my 3rd Kubota b7100. I seems like a great little tractor. I bought it from a dealer that took it in trade for a new Mahindra. Now here is my problem. I just got a chance to look it over at home today. I opened the hood and was looking it over when I noticed the battery cables were...

Sounds like an International Harvester (farmall) fast hitch. It was their try at hooking implements to the back of the tractor instead of a 3 point hitch. You could probably convert the disk to 3 point.

I am going to look at a JD 650 compact tractor with the 2 cyl yanmar engine this afternoon. The person selling says it needs an injector pump. He states it is available from Yanmar for around $250. I don't have much time to research this myself and if I want the tractor I will need to buy it...

I want to pump water from a small river into a tank and then use the water to irrigate my garden. If I purchase a roller pump for the PTO on my tractor can I use it to pump water from the river into the tank?

Can anyone help me identify the tiller I brought home today? I can't find any id tag. 42" width Offset to one side. The previous owner must have removed the slip clutch. The yoke to the pto shaft is snapped. I do not see a shear pin. However I have not had any time to really explore.