Recent content by Kyle87

  1. K

    Control valve?

    These guys may be a good source for your koyker needs. I bought a valve from them to convert my zl20 loader and had a very good experience. https://www.shortlineparts.com/
  2. K

    Farmpro 2425 loader plumbing

    Excellent thank you !
  3. K

    Farmpro 2425 loader plumbing

    Hello ! Does anyone know off hand or have a diagram showing if the supply to the loader valve comes direct from the pump and the return from valve goes to the diverter valve or do I have that backwards ? Thank you
  4. K

    Can this cylinder rod be welded ?

    I wanted to circle back and post my repair solution. I investigated welding it back together but there just was not enough room and no one felt like it would hold. I checked with a few shops and the price was not going to be worth repairing but the member here @wdchyd had reached out and offered...
  5. K

    Can this cylinder rod be welded ?

    Again thanks all for the replies and suggestion very helpful! I will take a look at that video as well. This appears to be a fully welded cylinder correct ?
  6. K

    Can this cylinder rod be welded ?

    Thanks very much for the replies and suggestions. Here is another photo of the other cylinder where the threads were not damaged however the rod end is also cracked
  7. K

    Can this cylinder rod be welded ?

    I had the rod end of a swing cylinder on my farmpro backhoe snap unfortunately. Are there any suggested methods to repairing it or am I stuck replacing ? Thank you
  8. K

    Backhoe  Looking for photos of jw/lw/hw 03 backhoe repairs and modifications

    Over the weekend I broke my backhoe pretty good unfortunately ! The subframe cracked in the same spot on each side and the control box pulled off the frame near the swing cylinder and popped off the swing cylinder pivot. Of course I had just dug our a stump and was praising my little tractor. It...
  9. K

    Loader  Farmpro 2425 / jinma loader valve replacement

    Hello I have been doing some searching and reading on the topic. Can anyone point me in the direction of the valve they used and how they plumbed it? I was ready to buy the ranch hand kit but unfortunately they do not have a valve source at this time. On keno tractor they offer a valve upgrade...
  10. K

    Farmpro 2425 steering leak

    Good morning, I have developed a pretty fast leak that Initially appeared to be coming from The steering box at the bottom of the steering shaft. However Now the steering shaft is leaking from the top as well, just below the steering wheel where the rubber boot is. I was hoping maybe it was just...
Top