Lucky Dog's latest activity

The black ones are so good that if one of them snaps closed on your finger..... well just be careful! 🤣

Perhaps in this specific situation, a pivot pin would be less likely to fall out? They come in all shapes and sizes. There's also...

Are your holes vertical and if so they should not fall out, if the spring is coming off, get a HD Pin like this...

The pin is free to rotate. That is the problem, it rotates around till the brush u-clips it. Then it's gone.

Is there anything more secure than this style of Lynch pin to the lower lift arms? I keep losing them while brush hogging. I'm thinking...

Be right back. Going for some popcorn:)

Me thinks the dealer dodged a bullet, and the dealer knew it too.

i agree machine is not remotely used, sat on a lot for a little bit, no digging machine would be that clean in 7 hours, the heat shield...

It's a friggin tractor, not a sports car....

It sounds like exactly what my 42 R is doing. I tried tightening the spring tension with no luck. My problem is that when it starts self...

I have a Wally - bx62S. It's a manual feed. The blades grab onto the trees and pull/feed faster than you would believe. It does...

Yes, the the wood is being pulled right through the feed rollers. I think I can increase the spring tension, I'll try. Thanks!

When “self feeding” Does reversing the feed rollers change direction the rollers are turning? If yes then it is a matter of friction...

Hello, I have a new to me Wallenstein 42R chipper. It has the hydraulic feed that runs off the tractor. Once in a while, when chipping...

Looks familiar. I spent about 3 hours on mine this morning. It's been too wet to mow for a few weeks. The brush was getting tall.