Recent content by Lucky Dog

Thanks, those look interesting. I just ordered a couple to try.

The pin is free to rotate. That is the problem, it rotates around till the brush u-clips it. Then it's gone.

Is there anything more secure than this style of Lynch pin to the lower lift arms? I keep losing them while brush hogging. I'm thinking about using a bolt and nyloc nut, but that would be a pain.

It sounds like exactly what my 42 R is doing. I tried tightening the spring tension with no luck. My problem is that when it starts self feeding the log, the end result is a broken shear bolt.

Yes, the the wood is being pulled right through the feed rollers. I think I can increase the spring tension, I'll try. Thanks!

Hello, I have a new to me Wallenstein 42R chipper. It has the hydraulic feed that runs off the tractor. Once in a while, when chipping larger pieces, the chipper seems to start self feeding, pulling the piece in faster than the rollers are feeding. Sometimes if I reverse the direction, it...

Time to chop some **** up.

I've struggled with keeping my gravel drive smooth for years. I currently use a box blade and back blade, but have discovered I'm horrible at using them. I see the land planes and Harley rakes on videos and they both seem to give a nice smooth level drive. My question, is one better than the...

Has anyone with a cab tractor added a Summit rear remote kit? Or similar brand? Any pics on how/where you mounted it? Thanks.

Send your neighbor a bill for brush clearing services.:ROFLMAO::ROFLMAO:

Got Wood

Personally, I'd offer to remove the $15 per acre and replace it with some mutually agreed on amount of beef.

I bought a 20' 10K trailer.

So far it seems like a good tractor. I run a 7' brush hog, a 6' flail mower and now this 6' blower. It seems to run all that just fine. I find the cab a little tight while getting in and out, but once seated I have plenty of room. My main complaint is the hydraulics do not have enough flow in...