Recent content by mark2610d

Well today I filled up at 1/2 tank and topped it off. Required 8.9 gallons. So that tells me this. First half is 8.9 gallons 2nd half is about 4.2 gallons.

I just got a new to me 2016 Kubota L6060 cab and love the tractor!! The one question I have is the fuel gauge seems to be not accurate at all. The tank holds 13 gallons and some change and when I get to 1/2 tank it goes from 1/2 tank to below empty in 1 hour. I recently ran the tractor for 1.8...

Was thinking about buying a new L6060 cab but was wondering if I might wait for the next generation of Grand L tractors. Anybody have any idea when we might see a new series of Grand L's? Maybe a 80 series?

Took a trip to check out the YT359C tractor. My first impression was WOW! The yanmar fit and finish is better than any kubota or john deere i have looked it. The attention to details is incredable. The frame is very solid! I like the cab roof design with its low profile stance and a real...

Well i just turned 3000 hours on my 2008 L3240 cab tractor today! Just wanted to give a report on how the tractor has held up since i bought it new in 2008. I have always done my own maintenance and did all the scheduled maintenance by Kubota's schedule. The tractor runs as strong as it did the...

Pallet jack makes a perfect way to do this job. I had to do this job on my 08 L3240 cab. Make sure you replace the bottom propeller shaft seal,sleeve two orings as well as new input shaft, and seal housing gasket. Mine was leaking from input shaft seal. My seal was totally worn out at 1700...

I have a l3240 that has a speed sensor and the three wires have come out of the plug that plugs into the sensor. (was into heavy brush and it got snagged) My wires can be slipped back into the plug but I don't know which wire goes where. If you lay under the tractor the sensor is on the right...

Well I knew it was only a matter of time. My flexable factor cab antenna broke off. It is a screw in type. Anyone know if you can just buy the flexable tip? how much am I looking at and where can I get a aftermarket tip?

Can someone please help me get the correct part to repair my kubota T1460 Garden Tractor. I broke the pto cable that engages the mowing deck so I went to my local kubota dealer and they looked up the part and asked me for my s/n off the tractor.and they ordered the cable and it was not the...

Sometimes (but not every time) I go to re-install my 724 loader back up I find that I have excess pressure in the loader lines to the point they will not connect without breaking the lines and bleeding off some pressure. Anyone else have this problem? What causes this? Is there something that...

Just wondering if anyone has any insight on when the next series of the GL kubotas will hit the market. Any rumors??

I'm in the process of building my pole barn workshop and need help deciding on a way to make my building look good while using a shed type roof. My story is I have been collecting building materials for the past few years getting good deals and trading around to get my materials for this...

I mowed the grass yesterday and did 5 acres in the Tennessee humid heat (about 90 deg). I had on my favorate pair of sunglasses while mowing enjoying the comforts of the cab. I got finished mowing and got out of the tractor and almost instantly my glasses fogged up and were soaking wet. This...

I have a yanmar tiller that slides to cover my tracks. I really like this tiller but I hate the tines because they are very fragile and they wear to fast. The yanmar does a great job of tilling deep and fine even in hard packed dirt. I break a lot of tines and wear a set of new tines out once...

I'm thinking about which of these two tiller would be the best to go with. The ccm looks to be very heavy duty buy the price is much higher than the sicma first choice. What are the biggest differences between the two tillers? What do you folks think? Anyone have any experience with the first...