Mattyboy936's latest activity

Here is the picture of the light. The other two is because it had just shut off when I took the picture.

OK, update for you guys. Radiator seems to be clear and is full of fluid. Every time I went to use it after a bit, a light came on...

I will check that tomorrow when I get up to the property

Sorry here is the temp gauge photo

Hi guys, a few issues I noticed while using my recently purchased 3510 for the first time doing a decent amount of loader work today…...

Hi there, I was wondering if anyone could send me the length and a picture of their Mahindra 3510 loader level rod as well as where the...

When you took yours apart. Was the detent groove at the bottom of the cap or towards the spring?

Ok, a little delayed because tonight was the first time I was able to get up to the property and work on it since I was last there… I...

Spool valve** ^^

That’s a good question. I did not try mounting the screw valve onto the bracket and just trying it without the cap on. Steel wool might...

With the cap and sleeve off will the lever move freely? Just need to make sure it's the sleeve restricting it and not something in the...

An update on the valve issue. I took both caps off.. brake cleaned the crap out of both removing all the crud off. I wd40ed the piss out...

😆 duh 🙄 that’s my blonde moment for the day. Next time I am up on the property I will take a look at the valve and try and clean...

Ok. Then assuming someone didn’t switch the sleeves up in the past, the groove should go up. I saw the fast dump option on your diagram...

Those are a little gummed up. Break all that free and it should work better. I think the step would go down so it holds the lever at...