Thanks for the thoughts. I am going to get some pressure gauges and test at the steering column port before I do any else. Supposed to be around 100 psi straight ahead and vary from 1100-1700 when turning.
As far as I understand the US. Data plate number is NT 5R1C 026025 T.
Should make it an open center. I’ve only had the tractor about a month and as far as I know it was not leaking before this happened. Thought maybe I had overfilled the transmission fluid because it was on the high side after...
The seal number was AL28553 and I also replaced the gasket on the cover on the other side. I’m not sure where the “adjuster” would be but I didn’t replace anything else other than the cap screws on both sides. I read down through the thread but it seems to more of a steering column rebuild than...
Question
My JD 2020 started leaking profusely from behind the Steering Shaft Arm recently. Thanks to this forum I was able to isolate the fault to the seal, I thought… I replaced the seal which did appear damaged and not a JD part.
When I started it it appeared fixed until I used it a bit...