Recent content by milesvdustin

I should add I didn't weld on the ROPS, I bolted it to the tab that had the SMV sign bracket attached.

Decided to mount a .50 cal Ammo can to my ROPS to hold tools, chain, clips, etc. Used some scrap 1/8 angle iron I had laying around and stick welded this up. Can is a light friction fit so I can remove if needed. Time will tell if I need a standoff down to the fender for support.

2018 CK4010HST. 130hrs on it, oil has not been changed but the filter change was done at 50hrs at the dealer when I bought it used. Oil level is correct in the trans.

I was working the tractor yesterday and needed the diff lock. LOTS of force on the pedal got it to lock, but to unlock it I had to stick my shovel handle under the pedal and pry it up, even after 100 yards of driving swervy to let it pop out. Is something bent inside the trans? I have been...

Thanks! Any idea of the chunky black stuff? Is there any harm or a way to add a pre filter from the tank? I store my fuel in justrite steel cans with some diesel kleen additive. I buy 5 gallons at a time, I only have about 8 acres to brush hog.

It was 115 heat index here today. I waited until 6pm to go out and run the tractor. A few tours in Iraq and I hate the heat. I hate being cold worse though. 20 mins oer hour of easy activity outside is about all I can take in this heat.

I use the Lucas red n tacky and I store my cheap rural king Grease gun on some shop towels in the cabinet. It drips a tiny bit. Like two drips per tube ish

I have a 2018 CK4010H Kioti and it was giving me a run of water in fuel lights with subsequent drops to limp mode. I did store it in am unconditioned barn since I bought it (early 2020 with 55 hrs on it.) It now has 126 hours. I did not have the tank topped off that I can remember over the...

Not the whole shaft, just the end yoke with the spline connection. I installed a new bareco pto shield and realized the slip ring collar was messed up. Just need that end piece and want one that uses a push pin type instead of the collar.

I bought a used rhino 260 rotary cutter and it needs the end that Hooks to the tractor pto output replaced as the collar that pulls back to release is bent and hard to manipulate. I want to install the kind that has a push pin instead. The Rhino part number is 00779516 but I can't find anything...

Maybe some big washers on each side?

The kit that does the whole shebang is 00779533 part number.

I just bought a used rhino 260 rotary cutter and the pto shaft safety cover needs help. Really just need the two plastic "bearings" and the two end cones that cover the slip clutch and pto coupler. Is there a good source for this that I don't have to buy the whole rhino kit for 210 bucks? Also...

I have a ck4010hst that the bar between the diff lock pedal and the actuator on the diff housing bent into a pretzel. I didn't stomp on it. Even driving in circles or having one tire slipping in the mud and applying pressure to the pedal would not engage it. Tractor is a 2018 with just over 100...

Yep but it was rougher than I expected or wanted to mess with. There are quite a few Alamo 88" mowers I found but they are all 5 hours away