Mtsoxfan's latest activity

In places that routinely lose the pins, I use a bolt, a couple of washers, and two nuts (the second nut locks the first one in place).

I have a Cub Cadet zero turn, but I'm sure many mowers have the same issue. As seen in pictures, there are openings in the deck around...

Thank you all for the suggestions. It sure looks like an easy fix to just wire pins to implement to secure in case of them working...

Yes, it seems like tractor 3pt, FEL, and BH work will often open up my Lynch Pins and losig them can allow a shaft to slide out and bend...

I buy Lynch pins by the dozen at flea markets, the last I bought were $4/dozen. I buy a bag every time I attend a flea market if they...

I use PTO pins in some place I tend to loose lynch pins. Then wire/chain them to the machine.

It never seems to fail, I loose them. This time, on my new flail mower, maiden voyage learning the ins and outs. While I do have some...

Deck not level, low side, high side, and when high side matches up against low side on next pass it shows more... Just guessing here.

You would not see me doing much of you describe wearing shorts. Aside from that; yeah, sometimes every day is Monday the 13th.

Update, I was able to start it by pulling the solenoid wire off the starter and then using my hand held starter remote button to engage...

yes, less than 2 weeks.

Damn, is that all? All that would put me in my chair for the night with a beverage of choice... Tomorrow is going to be a better day...

If it's somewhere you don't mind a temporary mess, Dawn dish soap and water. The soap coats them and they can't breath. It has always...

The powder will fill the nest from the bottom. The dust applicator has a 45 degree bend so accessing the entrance will not be a problem...

That wont kill all of them. Only make the numerous survivors really mad. Try a strong concentration of dawn dishwashing detergent in a...