Recent content by mxr662

Offer?

If the 3 point arms could be left on the tractor at all the time, I would keep using them. The arms are removed to install the backhoe, and the Pat's makes the arms awkward and heavy to remove/install. Cleaning up the shop, filling the trash can every week.

$100 plus shipping. Shipping will be around $25

Any way to repair the damage to the rod? Could make a new rod if we knew how remove the piston from the rod. Does this come apart somehow?

Got this a while back for my MT125. Move on to the Land Pride quick hitch. The separator got a bit bent. $150 plus shipping to continental US. Has pins, no washers. Fits in large flat rate box. Ship weight is around 25 lbs.

I used 4 flush mount ceiling speakers in my 30x45 shop. Nice consistent volume level wherever I am working. No moving speakers around or annoying loudness when too close to the single speaker.

The single switch is the lever for the three point. and the triple switch is on the roll bar with a plastic zip tie for now. I will probably make a bracket to better mount the triple switch where it is now. If I had it to do over, a double switch on the three point lever would be better.

Added four rear remotes and a flail mower. Summit hydraulic kit with custom brackets.

We referred to that as "swap till you drop"

Sometimes it is drop shipping. For example Supply House sells Mr Cool parts, and the parts ship from Mr Cool. But the eBay/Amazon deal is fraud.

Some of that is arbitrage. List a product on eBay, if it sells buy it from Amazon and send as gift to eBay buyer.

Just under a 100 feet of 36-48 inch deep trench. In some parts of the trench the hardpan was tough to dig through. Trench is for a new electric service in 4:inch conduit. My small tractor was worked hard and performed well.

This? Or Here?

Twenty-nine of these just sold at Richie Brothers in Dunnigan CA. Around 5000 + tax and fees. I registered for the auction but missed it somehow. Probably best to miss as I do not need one anymore. Andy Link to Auction