Recent content by Newblue

Put in a 2 post Bendpak. I didnt trust the floor thickness so cut out the concrete and dug/tilled down 14" Backfilled with peagravel and rebar. So I have a concrete chunk that is 14'x4'x12" to mount the lift to that is also keyed into the current slab.

I have had this before. I build Jeeps in my shop and had one come in for a lift. I saw one wheel had wallowed out lugnut holes and told him about it when he came to pick it up. Later on he calls me back and asked why his wheel came off. I reminded him I told him about the wheel and I had torqued...

So they replaced seal #12 and seal #2. How could they not remove the knuckle to replace this seal?

Thinking about it wouldn't a tech note damage in that area?

Would anyone have a link to the service manual for the TC45DA with Supersteer? I'm willing to shell out $200-$400 for one just so I can service it myself. Also the owner said that they didn't have to remove that part to do the repair. They replaced the outer seal on the wheel flange shaft and...

There is a burr on one of the hammer marks that if it is fully turned to the right it will tear the seal

After I called back again this afternoon I finally got ahold of the owner. He said that his techs that would have worked on that would not have done that. After back and forth he wanted me to pay part of the repair. After I said it happened at your shop he agreed to replace the part only if I...

Received no call yesterday afternoon. Called back this morning and talked to the lady in the servive department again and was told the owner would call me today.

Talked to Messicks and cylinder SBA344952751 is on nationwide backorder. Called the local New Holland Dealer to see what they are going to do. Service lady said the owner is supposed to call me this afternoon. We will see.

My cylinder looks different than those in the links. It has shorter ports on top and an extra port on the side. I appreciate the effort though!

Is this the Supersteer right side cylinder dlctcg?

Keeping this updated. After not hearing anything for a week I called them this morning and the dealer said the cylinder is not available any more so they are looking into getting the cylinder rechromed.

Dealer called me back this morning and said he didn't like his techs answers and asked for pics. Sent them and I called back a couple hours later to confirm that they recieved the pics and they said yes they did and are working on getting me another cylinder currently.

Oringinal hardware as it is the same on the other side. I believe the cylinder is original too. The orange is the primer I believe. Looks like they hammered the heck out of it to remove it from the knuckle. Why in the world would you hammer on the chrome part of the cylinder.