number two's latest activity
-
Nnumber two reacted to daugen's post in the thread Your last generator Maintenance Run with
Good Post.
since it was 111 degrees when i took my motorhome through Desert Center CA last Fall, I can't imagine you being out of power and a/c in... -
Nnumber two reacted to ruffdog's post in the thread Bercomac SSQA snowblower experiences with Good Post.
That is the same reason I need to plow BEFORE driving on the packable snow.
-
Nnumber two reacted to LouNY's post in the thread Bercomac SSQA snowblower experiences with Good Post.
I've used my inverted pull type in 30 inches of snow fall. No problems and it doesn't leave any packed tire tracks behind me.
-
Nnumber two reacted to shooterdon's post in the thread Bercomac SSQA snowblower experiences with Good Post.
I used my pull blower on 10” and it worked very well. I have a gravel drive and getting down to “pavement” is not a good outcome...
-
Nnumber two reacted to leonz's post in the thread Bercomac SSQA snowblower experiences with Good Post.
A Rammy 155 commercial single stage snow thrower for the Kawasaki mule and V bar carbide ice chains for the kawasaki mule. I grew up...
-
Nnumber two reacted to shooterdon's post in the thread Bercomac SSQA snowblower experiences with Good Post.
I recently sold my pull (inverted) blower but it worked well. They are not cheap, but it sure beats a front blower and the nightmare of...
-
Nnumber two reacted to RjCorazza's post in the thread Bercomac SSQA snowblower experiences with Good Post.
In a perfect world, I would have a inverted blower. I make due with a regular rear mount blower with hydraulic rotation and deflection...
-
Nnumber two reacted to fishhead's post in the thread Bercomac SSQA snowblower experiences with Good Post.
There's always a rear pull blower- mounts on the 3ph but you drive forward- many members have them. I have beeb using one since , i...
-
Nnumber two reacted to glenintenn's post in the thread Kubota 36HP 4 cyl oil plug falls out with Good Post.
Got one of these. They're expandable from 1-1/8 to 1-1/4" - Tractor Supply has a similar make and their web info says they're heat...
-
NThis is a good point. Putting a 3PH backhoe back on the tractor can be difficult sometime. Maybe most of the time? That is another...
-
Nnumber two reacted to anomad's post in the thread oil and hydraulic mixed accidently with Good Post.
What does the normal service interval call for? My Kioti calls for a hydraulic oil change at 400 hours. So you are right there. The...
-
Nnumber two reacted to Harry in Ky's post in the thread oil and hydraulic mixed accidently with Good Post.
I wouldn't worry much about it. Personally, I get tired of all the comments I see involving "change the fluid and filter(s)" every time...
-
Nnumber two reacted to oldnslo's post in the thread oil and hydraulic mixed accidently with Good Post.
How much oil does the tranny hold on that tractor? If 10 gallons like mentioned I would be far less concerned than if it only held 3 or...
-
Nnumber two reacted to RjCorazza's post in the thread oil and hydraulic mixed accidently with Good Post.
I use the same 1 gallon oil filling can between hydro and engine oil without cleaning it out between, but that's about as far as I go...
-
Nnumber two reacted to sunandsand's post in the thread Looking for 24mm or 15/16" pins with Good Post.
GRS, I mostly agree with you. I also modify all kinds of things, and usually (hopefully) improve them for my uses. I'm absolutely not...