Hello from Ohio,
Bought a 955 JD Tractor that would not start.
Yanmar 33hp motor Yanmar 51360 injection pump
Forgive me if i do not know the correct part names but
No fuel was getting past the IP. After new battery and working the
starter a few times the fuel shutoff started working on it's...
Hello
I got on a diesel forum and saw a guys video where he mixed 2 parts marvel mystery oil with one part Howes lubricant.
I put a 12 ounce bottle of the mix in our 2006 pre DEF sprinter van(the million mile motor) with every fill up.
Before using the mix: about every 500 miles I would have to...
I restored a 4400 JD tractor ...tractor #2 off the assembly line
with barely any hours on it but had sat outside for many years
and I used 80/90 weight gear oil in the front axle. I figured it
would protect better and not seep through the original seals.
I saw a youtube video then went out and tried it. Do not know whether it helps or not.
2006 Mercedes 5 cylinder diesel sprinter(No def) MH and 2014 chevy cruze diesel.
2 parts MMO and 1 part Howes Lubricant in the diesel fuel every fillup.
about 10 ounces in the 16 gallon tank and 16 ounces in...
I bought two 4200's and a 4400 and they fit nicely on a car hauler trailer uhaul.
well i worried about the inside width of their rails but they hauled nicely.
Long story there
anyway a car hauler should work.
will measure one to be sure
thanks gary
Thanks
I figure if i keep the hoe boom up high and swung to one side
and curled all in that should cut down on the needed trailer length.
probly should chain it up in case of drift.
thanks
Hello from Ohio,
I am thinking of buying a JD 4200 compact 4wd tractor with 430 loader and 48 backhoe with a wide bucket.
I am going to have to rent a uhaul car trailer to drag it a long way home.
Question:
Which end is the heavier end of this setup? Should i pull it on or back it on the...
Hello from Ohio,
I am talking with a fellow that has a Kubota X1100C RTV that has a blown transmission.
Apparently you can see daylight through the casing. Do not know the model year.
He is a few hundred miles away and the price seems more than fair. I have not seen it but
I am a full service...
I would limb it first. It is not gonna go downwards. I would pay
real close attention as i am limbing it to see if it raises upward as the limb weight lessens.
That should tell you how much pressure the stump is having on it.
If the stump is pulling up pressure then notch the top of the log...
I have had them all away apart. Hydro and sync shift.
The range selector is just a gear drive, 3 different rear end gear speeds.
Totally different from the Hydro. two different systems.
Check the rear sight glass for hydro fluid. Both use the same fluid. If it is low and the range shift fork...
Hello
I had a 1970 something mercedes 220D and in the owners manual
it said that if you could not find a diesel station you could fill up with
low grade gasoline with one quart of motor oil..
It really did say that
If you have welders you ought to have a torch I would either clean all the paint off within
a half inch of the area to be welded and gas weld it OR
I used to take a thick piece of brass that fits up tight to the weld area and hold it behind the weld area(it absorbs the heat) and sputter the...
I had the same thing happen to me once....
About 15 years ago we had a major ice storm here in central ohio Storm of the century 2005 2006 roughly. Power was out for over a week. Brush piled up both sides of every street like after a hurricane in coastal florida. Trusty generator and wood stove...