POGuy's latest activity

Go to the end of your owners manual and look at the parts picture or download on from HF website. The engine has two ball bearing for...

I feel the same way about my 13-year-old son. I remember how hard I was on my dad's push mowers.

Doesn't that drive you crazy. Last week i was repairing my wifes rolling seat she uses for gardening. I pulled a cotter pin and washer...

In places that routinely lose the pins, I use a bolt, a couple of washers, and two nuts (the second nut locks the first one in place).

Thank you all for the suggestions. It sure looks like an easy fix to just wire pins to implement to secure in case of them working...

Yes, it seems like tractor 3pt, FEL, and BH work will often open up my Lynch Pins and losig them can allow a shaft to slide out and bend...

Just get some large “R”clips and push them all the way through until they’re hanging, brush and limbs are not gonna pull them out, been...

My wife has asked me/ told me she would like to cut the grass. My response was that I have neither the time or the money to fix...

Like it's been mentioned, I'm going with the deck is out of alignment. Either the adjustment got loose or something fell off. You can...

I had this a while back on a 6' finish mower - more noticeable on turns. Scratched my head for a while - even changed...

The difference I've seen recommended is 1/8" to 1/4" higher in rear than front.

Make sure the tires have the proper inflation pressure. If one has less then the one on the other side the deck will be lower on that side.

Worn Air lifts will cause this predominantly. They also will throw slight clumps if you cut early in the morning before the dew has...

1/2” is too much, my Exmark manual says 1/8”-1/4” depending on mowing conditions. If you’re mowing short regularly you want less rake...

Tire pressure has always been the issue with mowers I have owned and used. Having tubeless tires on lawn mowers has always been a...