You are in limp mode. That is why no power. There is an OBD2 port on or near your fuse block. There is a “cheat sheet” on the internet that will translate the code from the OBD2 codes to the Mahindra troubleshooting codes I have it on my phone. But unfortunately I am unable to attach it here...
“A troll is a person who posts deliberately offensive or provocative messages on line”
Doing the math you have averaged 4 posts a day since you joined 12 years ago
Using Wikis definition as a guideline IMO most posts of yours I have read have been borderline trolling at best
Truth hurts but...
Had the same problem on mine. There is a switch or sensor for the scavenger pump on top of the transmission. That’s your trouble I think.
I have an open station and with out disassembling the platform I was able to change it with a little patience/ingenuity.
If you look across the top of the...
back in the day" when pretty much all equipment was open station. The name of the game then was to get the engine heat blowing on you. You have an engine running at +/-180 degrees and a fan built in use it. I have seen some pretty ingenious ways to get the heat from motors onto the operator. In...
"back in the day" when pretty much all equipment was open station. The name of the game then was to get the engine heat blowing on you. You have an engine running at +/-180 degrees and a fan built in use it. I have seen some pretty ingenious ways to get the heat from motors onto the operator. In...
#1 consideration for cutting cost "you get what you pay for" and how often do you want to replace your well pump?
Do you need a 3/4hp pump for a 100' well? The old well here is 300' deep and it used a 3/4hp pump. You may be able to go to a 1/2h pump. The price difference may not be that great...
My .25c worth....and likely unpopular with you
1, If there is available food and from the picture it looks like there is.....the beavers will return again and again and again. They were there long before you arrived and will be there long after you are dust
2, IMO Let them finish their work...
Warranty....its not fixed....you paid for warranty use it.Starts out slow.......hmmm......and left the dealer the same way and they did not notice. Starts fine or needs to crank over for more than 2 or 3 seconds?
I ask because it may be a fuel shut off/fuel solenoid issue
And there are many more PO'ed Kubota owners that say the same about Kubota's warranty when the manufacturer will not warranty abuse/negligence. Hope your ego is sufficiently stroked with your childish witticism
What colour is the smoke?.....does it clear up when the engine gets to operating temp?
If memory serves the way to check what kind of shape your glow plugs are in is to do a resistance check with an ohm metre check and make sure power is getting to them first.....it may be a pooched controller...
"117$ seems insanely high".....you just bought this. You have warranty.....lots of it
- when is the next filter service due after the initial service? 250hrs.. 500hrs more? First service is always eye watering buying warranty approved filters
- is it worth the 25 50 or 75$ saved to buy a non...
What does your owners manual say on the subject? Some sales men are suspect in their credentials when trying to seal the deal. My thoughts run to this. And I am in no way familiar with your machine. But with my M85...I use it watch the preheat indictor in the dash every time I start it. If the...
Not sure how much you use your chainsaw but if I did not know how to sharpen a saw I would
1, learn the fundamentals of what is needed to make a chain cut. And what is needed to allow the bit of the chain to cut. Don't forget to find out what happens when you get either wrong and how to correct...