Recent content by rackmaster2

Thank you, that’s what it was. I took to Henson ford and got it replaced

you can get the drill points and seals from R&H Machine 800-321-6568 couple manuals below

took out of barn today and after it warmed up, the Power shuttle high/low alarm light would blink red. it would blink 3-4 real quick then do a steady 4 then a steady 9, I assume that is a code 49? anyone help with this?

Look back a page or so, I posted them in a pdf file on this thread Or email me at woodsland1@hotmail

here are a couple of manuals that may help some.

the sensor will kill then engine within 5 sec after start up, of course it could be the pump, but lets hope not. if the sensor don't remedy the issue, a gauge will be on it

the part number for the sensor is 73379020 , i have it on order. I would have never found it myself online. ( listed under starters/alternators) My driver did take the cables off and reset the system, but unfortunately didn't work.

thanks, good advise followup, tried it, left unhooked about 10 min. didnt fix it, but still a good idea.

have a 2016 workmaster 60, the low oil pressure warning light came on and shut tractor down. tractor has 600 hrs and been well taken care off. will not start now. Ive tried looking up where the oil sending sensor or switch is located, but cant even find that on a parts diagram. or even that...

This is my solution on how not to fix one. I used to build a few home brew deer cams , so I said what the heck. I could not figure how to get the thing apart. so I took it to chucks cb shop, took them a while but they figured it out. I even did a video so others would know. cut glass off...

good information, I have a 5410 that has been failing on the rpm part, but sometimes it will come on. I had taken it apart, to look for lose connections, the whole circuit board is sealed in glue. its a pain to take apart. I replaced the stepper motor and it did not correct, so i sent to a...

i saw that on another thread and printed it off, Ill be sure and check it out, thanks,

Which repair place did you send to, i looked up on this morning and they wanted $500 ,

I put a new cluster in at 800 hrs a few years back and now at 450 hrs this one is not working . usually starts out as fuel gouge acts up first, then later the temp quits and finally the rpm/hr part quits. ( it does come on , on occasion) Since these things cost an arm and a leg, and are...

4wd does not disengage when rocker switch is turned back to 2wd. But it will eventually go back to 2wd usually takes several minutes. 4wd light does come on when you brake. when you tun engine off and crank back up, then it will be back in 4wd again. even when you were in 2wd when you shut...