I drained my hydraulic fluid to clean filter. I replaced fluid to the full mark. Now no FEL or 3PT action.
I move the joystick but nothing happens.
Yanmar 1500d
Help:(
The bucket on my Yanmar V1A Loader uncurls slowly even when empty.
I think the left cylinder is the problem.
I looked at a few hydraulic sites but saw nothing like the cylinder I have.
Mine has a long smaller tube on the upper end(about 11 inches)
The total body is about25.5 inches.
See Pic...
:) Thanks to everyone for helping with my brake job and hydralics.
I really did appreciate all the help.
I am including a few pictures. I did not take many on the buildup. some may be the same.
You guys are good.
PS YOU MUST GET IN THE CASE TO REMOVE AXLE AND BRAKES
yanmar 1500D Green
After a major t.eardown of the rear axle and cleaing the hydralic filter I haven't goet any movement to the loader.
The fluid is up to the full line.
Do I need to overfill to get the screen(filter) covered?
I need to repair the brakes, no adjustment left.
This baby does not have a convenient cover plate. I must remove the whole axle housing.
Where can I find a write up procedure so as I don't take of to much stuff.
I dont have any idea of what needs to be replaced.
HELP:mad::mad:
Well I was worried about the screw missing in the Valve cover.
I took the boot off and took a few pictures.
I don't know why the hole is empty but there is nothing for a screw to thread into.
See attached pics
I am having trouble stabilizing the load on my 3 point hitch.
The lower arms hit the rear wheels.
I tried to use chains but the only place I had to hook them to was the large clevis below the PTO and then to the bottom of the lift links on the lower arms.
I tried to keep as much slack out of the...
I have a Yanmar 1500d and would like to convert my joystick to have a free float position.
It is a VTEKS HD V1A loader.
Is it possible?
Could I afford to do it?
Thanks for any suggestions. Even funny ones