Recent content by Richard Tractor

The problem I found is described in my last post😊

Ok guys, I found it thank God🙏 The ball on the lower end of the lever arm that actually pushes the valve down has broken off, the backhoe can be operated with the cover plate off because the lever can be pulled further back , my touches are up on the mountain, I have only a wire feed at the...

Yes the Tractor has been exposed to the weather for years sorry to say,,,

Greetings guys, listen: I've had a couple small strokes, effected control of my right foot And some Memory is lost! Up date: There was a pin ! I removed the pin! Lowered the boom ! There is no lift, I can't raise it back up! And there is fluid coming out of the fill , I have the back...

There is no safety pin holding it in place,,,

Bucket movement is proper,,,

Outriggers raise and lower properly,,,

Front end loader works, that is separate hydraulic system,,,

No pin holding it

I fluid is clean and filled, just tapped the valves lightly with hammer, upper end moved slightly, couple inches two or three times now nothing again,

Tapped valves lightly with hammer, upper end moved couple inches two or three times then nothing,,,

Yes added fluid, fluid clean

By the way guys when I pull back on the lever to raise the upper part of arm the pump is struggling to move fluid an the ram extend about 1/2"

Haven't changed the hoses , Tomorrow, Never put off for tomorrow what you can do day after tomorrow, Mark Twain