The tractor is together. Was gonna make adjustments through the inspection plate on bell housing if I could figure out what to do. The adjustment bolt I circled in red are the ones I'm thinking needs attention.
The drive
The drive clutch is the one that will not release. I measured from top of bolts to base of clutch assembly on all adjustable bolts. The throw out bearing has sufficient adjustment for wear. I'm thinking the bolts, not the nuts (the ones that move levers in/out) are the ones at...
Its a dual stage clutch. I replaced the main and pto clutch disks as well as the pilot and throwout bearing. There is adjustments for the three release fingers and three for the pto clutch disk. I took measurements with dial calipers before disassembling and put it back together using those...