Thanks for the diagram.
Yes i have try to rebuilt, but i think the 2 plunger need to be replaced, it's like if i have internal leak and i have a big free play in the joystick.
I think it will be like 1/4 or 1/3 of price to install an aftermarket spool.
I want to discart the SCV to install the...
Hi,
I have a JD 855 1987, i have some problem with the SCV, but to replace it, it's like 3000$.
I found it dont have return hose, directly bolt and return on transmission housing.
The question is, can i remove it, block the return hole and install an aftermarket flow divider and control valve...
I'm alway in the lo gear.
When i bought it, about 3000 Hour i think, but i replace the tacometer, i should be near 3500 hour.
Yes over time engine loss power, but 2 week ago no problem (i can go too fast for the snowblower 54" and become a plow).
Saturday i feel i had less power and sunday...
Good morning,
Yes its a hydrostatic transmission.
Last time i have replaced fuel filter about 1 year and half.
transmission filter 2 years
hydrolic oil strainer and oil 2 years.
air filter and oil 2-3 month.
hydrolic pump 2 years
How do i can check fuel flow?
Hi,
(Sorry, not very good in english)
I have an intermittent issus with my jd 855 1987
Saturday when im blowing snow, i feel i dont have same power, i as need to go very slow, because rpm drop easily. Same thing if i drive fast uphill.
Sunday just had 1-2 times this problem and after no...
Hello,
I try to installer rear hydraulic for my 1987 JD 855 for the backhoe.
I find some thread how to install it.
But mine dont have plug at same place for IN/OUT hydraulic and dont find where i need to install the inverter plug.
I just cant add power beyond or someone know where i need to...
Hi,
i'm not very good in english, i will try to explain the problem
I have a JD 855 1987, i'm building my front end loader.
I have build boom and braket left and right same size etc.
when i'm installing it, the right side of boom and bucket are 1" too low.
Ive cheak with a beam level.
when a...
I will buy the PT13744 diverter plug and do the hydraulic to the rear.
does have any risk for rear axle, bearing?
does empty bucket in front is enought or maybe need to load it?
with weight in rear and front, any risk for the little frame of the tractor?
Hi,
I have a john deere 855 1987 with home made FEL.
I'm looking for a backhoe, i found a used one, but its about 1000 pounds.
doest it weight too much for the 855?
Of course i will no use the 3 point, i will build a subframe
thanks
I have 1/2 inch rubber hose and 3/8 inch metal hose to cylinder.
the tilt cylinder is 2 inch bore.
for raise i think its 2.5inch bore.
i use the original scv and line
Hi every one, im new here :)
Im french canadian and not very good in english sorry if you dont understand me lol.
I have a john deere 855 1987.
My problem is intermitant with the FEL, is a FEL homemade i have fit.
first one is, the right fonction and the regen when full right, have a...