Recent content by sarti

In my parts manual it lists D1803-cr-E4-LB2 also an D1803-cr-E4 LB-4 can you please tell me what LB2 and LB4 means so I know what I got Eng.#D1803-71CY8121 I think its the tier number but not sure I have an 2020 L-3901 Thanks

I have been trying to find the requirments for hauling equipment etc. on a 7k tandem axle utility trailer, such as what to use for a tie down... chain or straps and how many etc. tried thru state with no luck Thanks

I have a rck30b deck From a b2630 that I am trying to sell does anyone know if it will fit a b2650?? I think the 2650 calls for rck30b-a.. whats the difference if any thanks

What am I missing here not my first tractor ?? Just got a new 3901 and had the slider bars put on 3 point, the bars are on outside of the arms so when I spread them they hit the R4 tires.. They do not spread wide enough for my box blade and some other attachment pins...this makes for alot of...

Trying to decide on new tractor got it down to two I think kubota grand 3560 or mahindra 1635hst no cabs/with a loader only on either tractor,,always had kubotas but I am not sure on the DPF on the kubotas anyone with pros and cons of each thanks

Looking to buy bigger tractor any pros and cons on the mahindra 1635 hst with rop,, I have only owned Kubotas thinking about a change

I could not find the other thread on this and not sure I posted in correct place but I have a creek bridge with 16 ft span made from 2 treated 6x6 glued and bolted together Beams spaced same as tractor tires Right now I run my b2630 across it wondering if it would hold a 6000 lb tractor

Does anyone see the need to load their rear tires for loader work? Looks like pretty heavy tractor already

What is the correct HP on the B3350 some say 30 like the Kubota web site,, others are saying 33 Also have the new ones changed over to rail injection thanks

Does anyone know if Mark is still making stabilizer bars if so how can I get a hold of him? I tried an email I found but it won't go thru.....thanks

My B2630 seemed to be very low on power when starting. Figured had a bad battery, I had it tested and was told it was okay just low on charge. I tested my dynamo and had 14vac at idle and 40 vac at full rpm so I changed my regulator.. At the battery when idling I get about 12.5 volts and at full...

Looking for ideas, the left front wheel bearing (outer) on my b2630 has broken three times on now. The outer race on the bearing shatters, balls run to top, shaft drops and eats the seal, big oil mess too. This time it cracked the outer gear case cover..Never happens on right wheel. Not hard to...

Anyone ever have a opc module go bad? I have a B2630 that intermitingly blows the 5 amp fuse on the safety circuit. I went through all the wiring and switches, nothing looks bad switches all read good. When it blows I was just pushing hydro pedal to reverse (no pto on)..Any ideas, Thanks

I installed an electric start Briggs 122037-0550 engine on our Agrifab lawn vac, but there is a grey wire with white connector coming out of the engine does anyone know if this is an AC lighting wire or a DC battery charging wire I hooked up my fluke meter to it and it reads on the ac or dc...

Last year I bought the wife a new t2380, I didn't pay to much attention to the deck. It's a hanging deck not a floating deck..It gives a very poor cut in my yard, very uneven and gouges. Other than that it seems like a nice machine..Now she wants her Simplicity back. Anyone else have this...