Recent content by scarlo101

TN75 - Does anyone know how to eliminate joystick excess play when connected to the rear remotes?

The problem was the seat switch, the tape came off. I knew it was taped closed (previous owner let me know that). If you shifted the shuttle lever into the center the clutch pedal would need to be pressed to go again. If you do a quick shuttle directional change you do not need to press the...

Thanks Rick. I will check those two things out. I was under the impression that my seat switch had been previously bypassed (if that is possible).

Interesting. When first moving from a standstill I was always required to operated it by needing to press the clutch pedal or otherwise the alarm indicator will flash (and it would not move). Now I can drive anytime without ever using the clutch pedal? Could be dangerous if I accidently move...

Good day all. Under normal conditions with the tractor moving I can change the drive direction using the power shuttle lever without stopping and without pressing down the clutch pedal. I noticed now that if I move the shuttle lever forward or reverse from a stand still the tractor will start to...

Took it apart last week and disassembled it and put it back together and it works fine now. I see there is a 90 degree cable connector from the cable to the back of tack. There seems to be a lot of sloppiness in that area. So the cable is not broken but I suspect it will come back and at that...

Thanks for the info, I took a quick look today and I can see what looks like a mechanical cable coming from behind the instrument panel to the mid area of the left side of the engine (drivers side). I will call the dealer to see what is available to purchase.

Good day all, Yesterday on my TN75 when I started I heard a little bit of a different startup noise. I did not immediately notice anything wrong but later I noticed that I lost my RPM needle & hr meter. Is it common for this to happen? Has something disconnected or did the cable break? How...

My TN75 is M20 x 2.5. I did the same thing to install a 2" receiver for my winch.

Can I ask why you would add biocide to your diesel fuel? Under what circumstances and frequency?

Thanks for the info. What type of FEL control is on this tractor?

Good Day all, So I finally got my winch installed and operating on my TN75. It works great, and FYI I just use it occasionally to pull out the far away and hard to get at log. Even then, I don't do a constant pull. This NH model has a Power shift which means I can forward/reverse without...

Well I am sure this has been beaten to death here, but since I am relatively new here, and the cold weather is here I thought I would ask about diesel fuel conditioners and additives. I don't generally put on many hours (NH-TN75) in the cold weather. My first question is are they really...

Hello All I have a wireless remote 10000 lb winch on a 2" hitch that I can use on my truck and on the rear of my tractor (3PT hitch 2" receiver). I am planning on building a 2" receiver on the front of my TN75 NH tractor for dragging out logs in the woods. My 2 questions are, am I in danger...

Good day all, My NH TN75 Stoll FEL (new tractor to me) is connected to the rear remotes which is controlled with the joy stick. Currently my manual third remote is not being used. (I have a hydraulic blade and may use it for a grapple some day) With my current setup, I do not have and miss the...