Recent content by shakin

that should do it. thanks

i have a montana branded ls 2840 and im looking for filters that dont come from the dealer, does any one have cross refrences to say a napa part? to include fuel filter. thanks for your time

will the tractor supply fluid be satisfactory in ls built 2840. its almost time to change it and the dealer recommended napa stuff in cold weather makes my hydraulics not work until l i idle it for 20 25 minutes in weather above 40 degrees it works fine.

looking for a replacement rear light the one with taillights and flashers built in, not the round petersen flashers. chute fell off chipper and remover part of it from my fender.

has any one experienced this? trying to change belts following directions in manual, it says to remove tops of pillow blocks,remove guide bolt and lift flywheel until pulleys fit together. Then change the belts and lower flywheel back into position. my problem is the bearings wont come out of...

one issue i have had since the beginning on my 2840 is sluggish or non responsive hydraulics in cold temperatures, i have done all scheduled service at the right intervals. i am using a napa hydraulic fluid that my dealer told me to get. in 10 degree weather if i dont run the tractor 10 to 20...

i have a cub riding lawn mower, just hit 50 hours and the display flashes change oil. i did thought unhooking the battery might reset but it didn't think it's a lt1046 but i'm not sure it's 18 hp kohler courage engine. the red light that flashes is quite annoying. anyone know how to make it...

i have a 2840 gear. when i engage my pto without a load it goes in smoothly with a little or no crunch, now when i have an implement on even with letting it settle out and clutch fully depressed i get some grinding sometimes i need to double clutch while holding the pto lever in order to get it...

is anyone thinking we might have some issues with our tractor supply line with north korea playing around with nukes. it seems to me that they are determined to continue their war. i'm concerned that we are relying heavily on these countrys for alot of our every day items including tractors.

i have a 16' flat deck trailer. with the ring style rims, with bias carlisle trailer tires. the trailer has a bounce to it when driving it worse when it's empty. when i spin the tire with the wheel off the ground it almost appears the tire is out of round not sure about the rim. are thse rims...

what is the proper way to set up you're bush hog for general cutting. i have a squealer 148 with a top link no chain and a solid real wheel. i guess what i'm saying is do i try to keep the unit level? lower it till the wheel touches and adjust top link to maintain. or do i allow the skids to...

i have a 5.5 hp reversing tine walk behind tiller i bought from a friend cheap. thing is it needs tires and a new drive belt. i just went to the cub site and the #'s on the tag dont seem to work. are there anyone who has info on these i'll provide #'s if someone can do better things with them.

who is the company who manufacturers the 1999 1530 i know it's a shibura engine i'm assuming thats japanese.

maka is there any reason not to run a 67 inch tiller on my 2840 if it dosen't lug the motor and dont affect shaft speed? also what arethe filter #'s for my mitsu fuel, engine oil and hyd filter. hoping there are wix #'s or something like that available. thanks

just read a post on price per hole with a phd. and was thinking how do you guys price tilling just got me a tiller and will probably start doing some travel will be limited to say 15 miles.